Not-All-Natty's picture
Not-All-Natty
  • 4
2399

NPP is this Normal?

ad

I recently purchased NPP for the first time. I purchased a few vials of NPP150 10 ML vials. The best I can explain it is that in the vials there is a white crystal substance sitting on the bottom of the vial. I thought that maybe they are the steroid crystals and was never mixed well in the oil. So I took one and tried to mix it. After an hour of heating it with a heating pad and shaking it it finally mostly mixed. I say mostly because there is still one flake that will not mix. After it cooled it was like one solid substance in the vial that had completely solidified. Once heated it liquefied again. Is this normal for NPP or do I have a bad batch?

Achak's picture

The issue is the product is considered a high mg product dosed at 150mg/ml. This requires more solvent or a stronger solvent to completely dissolve the active ingredient. The UGL didn't utilize the proper solvent ratio when making this product. Their reasoning behind this was probably to avoid a higher amount of PIP. If EO was used as the carrier this could have most likely been avoided. Regardless this isn't a major issue. The product is still good. Take a pot of water and heat it up under medium heat. Drop your vial in the water and monitor it. The heat will dissolve the crystals. Remember heated liquid expands. This will increase the pressure in the vial. Too much pressure means explosion.

ECinfidel's picture

I had a similar issue recently w/npp 150. Took me a few tries, but just got it to hold the other day. I found the problem was super small crystals that were hiding under and around the stopper. Any crystal left behind will bind w/the remaining hormone and cause it to crash. I tossed all the vials in a sealed Ziploc, boiled water, turned it off, amd dropped the bag in for about 20 minutes. Shaking them up a few times during. Been about 5 days and all is good thus far.

Sam I Am's picture

Very common with that compound.
Use a hair dryer.

Owes a Review × 1
Not-All-Natty's picture

When you say crash do you mean separate or spoil?

I trust the source. I have never had any issues in the past. I have always have good results. I do think next time I will go with NPP100 vice 150. Smile

Pmob's picture

Your good. Just use a little heat before pinning and lightly twirl. Your 100 could also crash just so you know.

In a promo × 1
Not-All-Natty's picture

Thanks everyone for your input. I increased the heat and it mixed with no issues. Looks like the heating pad was not enough heat to get it to combine again.

More by Not-All-Natty