+ 3 Injection Tips for PIP Free, Pain free, TRT, or running multiple compounds.
I know most people on here are old school and would probably say just Man Up you twat, but I'm a giant puss so I'm just writting this up to help other twats.
You can load multiple compounds into the same barrel.
You can pin subq daily into your buttcheeks for pain free and pip free injections. I have muscle tissue scaring from pinning my shoulders for 10+ years. Switched to subq and my bloods show no difference. Still gets absorbed.
If you pin Subq, You can buy 30G 1cc 1/2-Inch insulin syringes for about $15 for box of 100.
To draw, you want to buy a seperate box of 18g to 22g 3ml syringes.
I fill 7 insulin syringes every Sunday and store in my closet, havent had any crash on me. I havent gone past 7 days so I cant say how many you can prefill but 7 works for me.
Example Cycle
Test 300mg/ml and I want to run 630mg test per week.
Primo 150mg/ml and I want to run 400mg primo per week.
Mast 200mg/ml and I want to run 200mg mast per week.
Sunday would look like this.
Remove 7 insulin syringes and all the coverings.
Remove the stopper from the back so you can access the barrell to fill.
Test - Use your 3ml large gauge needle and draw 2.3ml of Test. 2.3ml is a tad extra, sometimes you lose a little as you fill.
Fill all 7 insulin syringes to the 30unit marker. Prop up the insulin syringe and lay it down at an angle so the oil doesnt leak out.
Primo - Use your 3ml needle to draw 2.8ml of Primo
Take the insulin syringe with test in it, and add 40 units of primo to each one bringing the total amount to 70 units of gear. Prop it back up
Mast - Use your 3ml needle to draw 1.2ml of Mast
Take the insulin syringe with the test and primo and fill them with 15units of Mast to each one bringing the total amount to 85 units of gear in each insulin syringe.
Re-Insert the stopper into the insulin syringe as you finish each one. Tip it back with the needle pointing up then give it a few flicks so the air bubbles rise to the top, then apply pressure to fully insert the stopper. Push the remaining air out until the oil meets the surface. Cap the needle and store room temp for the week.
Now you have 90mg of test, about 58mg of Primo, and about 28mg of mast in each insulin syringe ready for each day of the week.
When you inject subq, every now and then you might get a knot if you injected too quickly or a small bruise. It happens. It will heal.
I can pin my glutes for about 3-4 weeks before I give them a break rotating between left and right side. For the 1 week break ill pin the fat on my obliques or thighs if I can find any. Otherwise i'll do a week of IM into the thighs or lats. Then back to the glutes. If your body fat is above 15%, you can literally just pin anywhere on your butt cheeks theres so much fat there you have plenty of space and since the needle is so short you wont hit any nerves.
You can take a plastic zip lock bag, place your insulin syringe in the bag and zip it closed, and run the barrel under hot water in your sink if you want to heat the oil up for smoother injections.
Benefits of daily injections are noticeable, more stable levels, less side effects, less mood swings, less acne, less dips and upswings in energy.
You can confirm this by using steroid plotter and seeing the peaks and dip differences from daily injections compared to EOD, E3D, E5D or keep a log for yourself to notice the difference.
When I run tren I dont mix it with anything else. Just personal preference.
There is a second method that I won't go in to today, you can buy a 50ml or 100ml vial, empty all your compounds you are running, do the math, and draw daily. I wouldnt do this if Tren is one of the compounds. I'm sure you could but to me it doesnt sound like a good idea.
I've been doing the Sunday preload method for 3 years now and haven't had any issues besides a few knots here and there. Sometimes a few bent needles. A couple times I knocked over all my preloads being a dumby and the oil leaked out. Mistakes happen but nothing serious. I used to believe that SubQ didnt absorb as well, but my bloods tell me my body responds the same to IM as it does SubQ. Wish I had known about this when I first started. Good luck, hope this helps anyone tired of doing IM injections.
- Bookmark
- 3
- 0
Great info!! I do the same except preload slin pins. I use 27g 1/2 inch on a 3cc barrel. I’ve found it easier to use rather than a 1cc slin pin because .5 or 1 ml of oil in a 3 cc barrel the plunger has less length to travel Making it easier to maneuver when I pin lats or any area that is harder to maneuver with. Also I can use the callis area of my hand to push with rather than my index finger.
No offense but my adhd wont let me read all that shit lol. I'll stick to just poke and go on my day. Inject some susta350 and there is no heating pad or hot shower, rotation schedule or any crazy thing that makes it a 45 minute injection thats going to make it PIP free
Haha you need to hit that mitochondria stack and say goodbye to the adhd. 5mg methylene blue, 250mcg slup322 3x daily, 5-amino-1mq 50mg 3x daily, mots-c 1mg daily. Super focus and energy. Helped my adhd and ocd way may than any Adderall or vyvance.
Do you find some brands give really bad inflammation when injecting subQ (but might be fairly tolerable brands for intramuscular injection)? You're right, the data is clear, absorption is the same for either route. I really tried a year ago, injecting into belly fat with a shallow needle, but I would get these massive red welts that were hard, and lasted anywhere from a week to a couple of months. Was brutal, especially during pool season...
I've only stuck with vendors that use MCT oil and its been a non-issue. I wouldnt do test suspenion or any liquid oral. Once I injected oral tbol subq and it was... next level burning pain. Even deep IM was still pretty painful. Its like injecting glass shards and burns for day for me. The belly is a sensitive spot for oil injections. It can be done if it's 30 units or less but for me always welts up and turns red. I leave the naval area for Gh and peptides since they absorbs quickly. I try to stick to only vendors that use MCT and .22um micron filter.
There is the concern that some oils have BB/BA concentrations that actually corrode the rubber plungers in the needle - so by preloading and leaving for a week, you are actually injecting some dissolved plastic/rubber. Not good. This would be specific to some brands/formulations though, not a universal phenomenon. But something to think about.
VigorousSteve has spoken about this several times in his videos, and even suggests a simple hack to see if your UGL brand has BB/BA levels that are too high - put a pindrop of your gear on your fingertip, and then wipe the numbers on the side of the syringe. If the ink rubs off, you shouldn't preload that oil, it's going to corrode the stopper.
I really like your idea of buying sterile empty vials and mixing all the compounds for the week/month/blast in there!
For sure, MCT oil, cottonseed oil, coconut oil, those carrier oils seem to last the longest without eating away the plastic. I wouldn't touch a preload with BB/BA or EO. Gives me inflammation and PIP. That was my fear too of not loading an entire months worth of pre-loads. 7 days seems to be the sweet spot.
Super helpful for the future if/when I run multiple compounds. Now you just need to find a way of securing your needles when filling so they’re not easily knocked over.
Super curious as to why you won’t mix Tren in your syringes? Why?
Only reason for me is if I knick a vain and get tren cough while only injecting 50mg a day, it's not that bad or long of an injection, and doesn't burn much, if my tren is mixed with 50 units of test and I knick a vein I got a long ways to go until it's all pinned as I'm coughing away. Tren shouldn't burn but sometimes you get a crappy source and it's got some sting to it. Same reason I don't mix carrier oils in the same syringe. You definitely can, but if 3 of your compounds are using MCT which you respond great with and the 4th is using EO which gives you crazy PIP and inflammation, then you just tainted the entire shot with EO and you're getting PIP the whole week. I've mixed tren and test in the same pin but one long ass burning coughing shot was all it took for me to give tren it's own stand alone barrel. Just personal preference. I used to actually like the tren cough as crazy as it sounds, the warm burning of the throat and taste, but not anymore haha.
That’s wild. Maybe it’s different as I run enanthate but I’ve ran over 10 Tren cycles over the years and I’ve never had the Tren cough. Def getting the burning soreness on this last source though from the Tren.
The tren cough is a once in a life time experience. I don't know all the science behind it, but apparently the tren enters the blood stream from knicking or hitting a vein, and then, for me, your throat gets really warm, and you start to taste diesel or gasoline, that part I like, then the warmness turns into a burn, then the burn turns into a rampant caugh where you feel like your throat is closing, and then it fades and you are good to go. Fun times.