+ 4 injection technique/ sterility.
There is probably a Million forums on this topic here on eroids but a question was asked to me so I'm going post a new forum with how I aproach the situation
-
Supplies: 3 alcohol swabs, 1 cotton ball, I use bd luer lok 21 g 1 inch to draw and one 25 g 1 inch or 1.5 depending on Injection site.
-
The prep: use one of the alcohol swabs to sterilize the vial or amp (yes the outside of the amp) if it's a vial leave the swab on the top until you are ready to draw.
Open your pin draw the same amount of air into the pin you plan to draw from the vial pus said air into vial and draw the oil. Put the cap back onto the needle remove the draw needle from the syringe and put the new one on. Next clean the injection site you chose to pin, it's important to make sure the alcohol drys fully because that's when the area is fully sterile -
The injection: get comfortable relax the muscle as much as possible. With your index finger and thumb tighten the skin of the area you plan to pin and give it a little pressure (this makes it to where you won't feel the needle break the skin) push the needle at a slow but steady pace strait in no angles. Once you are in aspirate this is extremely important! Anyone using aas knows why. If blood fills the syringe pull it out change the needle pick a different spot. After all that start to push the oil in, also slow but steady. If you just ram it all in you're going to be hurting. After you remove the needle immediately cover the spot with the cotton ball apply pressure and massage in a circular motion for a min or so. After that use the third alcohol pad to sterilize the area once more.
Sterility is the most important part of pinning an infection can kill you!!!
- Bookmark
- 4
- 0
One thing that should be mentioned (that shouldn't have to be mentioned) is that you don't need to bury the pin, 5/8"-1/2" should be plenty (unless you have an excess of fat and need to bury the pin, but then it turns into a question of if you are physically ready for AAS)
This so yeah I didn't bring that up somewhere like a shoulder or a quad you shouldn't have to bury the needle but as some guy would agree with me on this I'm sure is on glute injections you should go deep cause even on leaner guys there is a pretty good layer of fat
This link is the first link that comes up when researching "Inejction Sites" in the magnifying glass. Some incredible info, and the comments are great too. (I'm adding this here for future eroiders who stumble upon this thread.)
https://www.eroids.com/forum/steroids-qa/steroid-cycles/pin-sizes-and-in...
Yeah that guy nailed it. Good read thanks bro.
I agree w guys below. I quit drawing back on the needle. Another thing I do is only use slin pins. Easier for me and I can spot inject a full cc about anywhere, except glutes.
Nice write up man plus 1
Yeah we all kinda have our things. I was just writing about how I do it since someone asked me how I aproach it.
Just a couple of things I do differently. I don't leave the alchohol swab on top of the vial. The alcohol doesn't get a chance to dry on the vial then. I also don't aspirate. My Doc/nurse never does so I don't bother with it either. I have tried it but all it does is give me pip because the needle moves around more in my muscle. Also I would recommend that you don't massage the injection site right after injecting. Pushing that bolus of oil around right away is going to damage more tissue and cause a greater buildup of scar tissue. Everybody has their own little pinning rituals, so as long as it works for you and sterility is top importance, then great.
Same here. I don't aspirate either. I know from the medical field that it's not needed and no one really does it.
I just once found an article about if it's dangerous or not if you do it or not and what happens when you actually hit a vein. Can't really remember what the actual final conclusion was but I know that there's no evidence of short or longterm damage, if you came to inject a compound that way by accident.
And yes, agree with makwa on massaging as well. I'd avoid it by all means, you just increase the chance of scar tissue with rubbing it. Rather use a technique like the "Z-track" if you don't want any blood or oil coming out.
But yeah, each prefers a different way. As long as it's kind of right and definitely sterile, I guess there are more ways too it
wow so all these years i havent been aspirating and thought I was the only one! lol
Man yall crazy I hit veins all the time I have to move spots cause the syringe fills with blood. I just don't trust it only spit I don't hit veins often is delts
Just as a sidenote. Quick findings on the topic. When you have the time and feel the need, there are lots of studies on that topic as well.
But yeah, if you feel more secure with aspirating, just do it. Both ways seem fine
So I get what it's saying and all but I was using a nandro test mix two cycles ago and pinned a vein and started coughing my brains out for like 3 minutes felt like eternity and my heart was beating extremely fast
AND I realized what you said. I did actually read it, but still I'm saying that it's not necessary BUT do it if you feel the need for it. Both ways are legit
I know bro no hostility on my part I'm not saying wither way is wrong dude. Nothing but respect on my end for the people with more experience
Do I sense some sarcasm? ;-)
As far as and damage from hitting a vein yeah there is none really but I pinned a test cyp/Deca and hit a vein and I was coughing uncontrollably and my heart was pounding i thought I was going to die so I do it everytime and as far as mass aging it this is something I've done everytime since I started so yeah a ritual
I forgot the air you draw into the needle push it into the vial damn almost a perfect post lol
RustyhookerClick edit...fix...save. boom!
My man thanks!