posted Fri, 10/17/2014 - 11:52
1453
heating gear
ad
I heated up my vial for the first sustanon pin in glutes with a heating pad. Shockingly I felt nothing, not during and not later. Next couple pins were delt and quad where I experienced mild pip but not bad. I only wrapped vial in regular blanket for awhile so it wasn't cold. I will see how things go but if I need to heat gear again (which I will.try to.avoid) rather than heating and reheating vial I thought this would be better. Load sust into syringe, put cap back on and wrap in medium heat pad. Then go shower, prep injection site, change needles, and go. Bout 15 mn later. What do you guys think? Supply in vial stays cool like label says and gear is warmed only that for pinning that day. Thanks!
- Bookmark
- 0
- 0
Crashing is when the compound falls out of suspension. It will look like small ice crystals in the vial. To fix this, you place whatever needle you draw with and heat it in an oven. I've done this with a friends products. However, it is not guaranteed that it will not crash again. His crashed because he left it in his glove box for a couple days " in 10 degree weather". We were able to bring it back. We also filtered his gear into new vials. I always suggesting filtering gear. "Watson exempt" but filtering will ensure you don't have any bacteria or contaminants that could cause an infection. Especially if you're running product from a ugl
Heating the oil just isn't necessary. Even with a 25g it isn't that difficult to inject most products. I would only heat if it crashes.
What exactly do you mean by crashes? It goes bad then you bring it back with heat? How would you know this?
I have actually ruined a vial by repeated heating in a heating pad. I let it get too hot a couple times and the oil turned quite dark. I've since switched to using a hair dryer. It takes seconds to heat a vial compared to 5-10 minutes with the heating pad.
I heat the vial with a hair dryer so the oil draws easy (I use a 22g) then heat the rig once loaded for about 10 seconds and pin with a 25g
I draw into the syringe and then run it under low warm water. The cap keeps its sealed so you don't have to worry about contamination. I always heat up my oil
I just load the syringe and put it in heating pad for 10-15 mins..i never heat up the vial unless its crashed.
I think I have to agree. Thanks for all the replies! Sounds like the hair dryer or heating pad on the syringe itself is the way to go. I am gonna keep pinning for now just at room temp to save time just by wrapping bottle in blanket so its not cold. If pip gets annoying, I'll bury the loaded syringe in heating pad while I shower. 25 guage 1" pretty versatile for glutes and delts? Changing subject
To tell you the truth I've found no difference in pip by heating. Just makes the oil thinner and easier to push thru the syringe
I keep meaning to buy a heating pad that's definitely the safest way to do it.
nobellabsI never heat up my gear.
I used a 18g needle to draw and a 23g to inject... fast and easy.
Sust 250 and 300 should be painless or very close to it if well made...
I like to draw then run hot tap water over the barrel before pinning. 1 cc heats up a lot quicker than 10 cc.
I used to do the same but i worry about sterility. Am i just being paranoid?
I think we can never be too paranoid when it comes to sterility. Just take precautions and use process of elimination when there's an issue.