MonkeyMagic's picture
MonkeyMagic
  • 13
4077

Some noob questions on pins/pinning

ad

If while pinning I were to draw back some blood into the syringe, what would I then do? Pull out part way and push back in at a very slight angle to avoid the blood vessel? Pull out completely and re-inject at a different spot? Get a new needle and try again?

Is it ok to inject with the same needle as I drew the test out with?

What are your thoughts on 23g to inject?

Sorry if this was posted elsewhere, been reading and didn't see it.

Thanks in advance.

caster's picture

is it ok to just use a 1mm syringe for shooting test or is this too small? eg shooting 250mg/1mm?

MonkeyMagic's picture

Excellent input, thanks guys.

One more question though.

Is it doable to use a 23g to draw from, I know a lot of people say draw with 18 or 20 and inject with 23 or 25. A common counter is I've seen suggestions to heat up the vial before drawing to thin out the oil a bit but the instructions for storing test say to protect it from heat. Thoughts?

Frank Columbo's picture

I draw and pin with a 23g. I've had zero problems this way.

Bennyblanco's picture

Well if u can pin with a 23 g there is no reason u can draw with it. I have a mate who uses 23g to draw (from amps) cause he says he sometimes gets tiny shards of glass in the bottom and uses a 21 g to inject... I personaly wouldnt use a 21 g to inject again its too big for my liking, and I find a 25 g hurts cause of the pressure getting it out. 23 g is the mother fckin bomb! If u get a bit of blood when u aspirate tkae it out completly, push out any blood, change the needle find a new spot and do it again, u can use the same syringe and gear Smile

jpal's picture

if you draw blood pull out and inject in another spot and you should change the needle after you draw and i i use 23g for my glutes and 25g for my quads and delts

MonkeyMagic's picture

Thanks for the input but I've got to ask, what is the reason for changing out the needles for drawing and injecting?

Also, would 23g be ok for quads?

And one final one, I'm getting a sharps container for the used needles, what do you do with it when full?

jpal's picture

you change the needle because it dulls it when you go through the rubber on the vial and 23 will be fine in quads. When the sharps container is full you bring it to a pharmacy and they will take it

meandriver04's picture

Question guys, I'm new to injecting, what would be the best size to order and to inject with, thx

meandriver04's picture

Question guys, I'm new to injecting, what would be the best size to order and to inject with, thx

jpal's picture

sharpie containers are free

MonkeyMagic's picture

How does one get a free container?

Bennyblanco's picture

Needle Exchange. UK has them all over every city... I think Canada has the same. US I think it depends on what state u are in... U can also buy sharp containers online, but there is no point buying it if it is going in the trash and not back to the exchange. If it goes back to the exchange they will give u sharp containers, if not then use what the lads said a liquid laundry detergent bottle and just tape the lid closed etc and into a bin/garbage bag whooooo