posted Mon, 11/19/2012 - 20:26
2540
Test-E 400 pip
ad
I'm on second week of test e and tren e. I shoot tren in my delts 400 mg per week . This is first time ever trying test-e 400 and all 3 injects so far at 1 ml in glute 2 times a week have left baseball size lumps on ass damn near. This is my 12th cycle and my body has done fine with test cyp 200 or Iran test -e never probs with tren either. I take extra hot shower right before and also run needle under hot water to warm oil and still doesn't matter. Also inject very very slow. This test is from a very very reputable supplier on here very highly ranked. Should I trash the gear or any ideas? I have a back up stash of test cyp and a pile of Iranians to fall back on. Just bummed this shit was expensive
- Bookmark
- 0
- 0
I always use 25 ga 1 inch for delts and 23 gauge 1-1/2 for glutes
56tooAlthough I agree all mentions below are possibilities, the fact is 400 is still FOUR HUNDRED!! Thats a lot of powder and little oil comparitively. I would bet if u used the same stuff at 250 you wld have no problem.
x2 - Those more prone to PIP can suffer with these higher concentrations. Doesn't tend to bother me personally, but I know guys that have used 400mg test from the same source as I have and have found it very painful whereas I have had no issue at all. We're all different and some of us are more prone than others unfortunately.
Anonhow long are you pins? if you're using the same 1" pins as you may be using for your delts, you aren't going deep enough into the the muscle. need 1.5" pins for glutes. not only are the glutes a bigger muscle but they typically have an added layer of addipose tissue to penetrate before reaching the muscle. 1.5" pins will get you deeper where you need to be.
doesn't sound like virgin muscles, since this is your 12th cycle. i doubt it it the gear, but maybe... i've gone as high as 500mg in 2cc's into the glutes with minor to no swelling the next day, but all our bodies are different.
Youre going to have to cut it with oil. Or your going to have to heat the bottle each time. I do just fine with the 500mg test E per ML that i use by using that method.
good luck bro. hope you dont scrap it.
It is also possible that it could be the oil that suspends the test that doesn't agree with you.
No1its 400mg per ml obviously its gong to carry some pip