posted Fri, 06/17/2022 - 03:46
1797
REDACTED Thick Cyp
ad
Just ordered some CENSORED C300 cypionate, and the stuff is thick. It has good reviews, and I had a great run with the enathate E300 before. I'm getting 9 day lump and pain. First 2 shots in the glute, and just did the 3rd in the quad. Even after rubbing it in, in a hot shower, the pain is there the next morning. It's pretty much rendering me unable to work out the area. I'm not even sure I can get on a cycle for cardio. I could try to push through, but I really don't want to inflame anything. I want to run (2) 150mg shots per week, but I'm afraid it's going to mess up my workout protocols.
Any suggestions?
- Bookmark
- 0
- 0
basskiller88Previous cycles I switched injection sites and it was fine
Have you tried delts?
Both glutes and one quad. The 3rd shot in the quad ended up rendering me bedridden for 2 days. I've never had this experience in my 15 years of use. i had to toss 2 bottles.
RustyhookerNeed 4 points of injection....hot pad is best friend. All else fails...toss and pct
TricepatopsNot suppose to massage after injection.
I remmeber along way back you would notice more gym bro’s doing the pip walk. Not so much anymore
Don't buy overdosed gear.
I had great results and no problems with E300 in the past.
Delete the brand name. Keep brands out of the open forums.
No sense trying to fit a square peg into a round hole. You will be miserable at best and end up with an abscess at the worst. Switch to a different brand.
I think I’m going to have to. That’s back 2 back sources that haven’t worked out this summer. Both my go to dependable ones. I’m going to have to find something new. :/
You can also order sterile oil and add some to your syrenge to cut it that works wonders the high mg is probably what's causing your issues some people can take high mg gear with no pip
Try warming it up before use, that might help bro.
I'll try it.. I figured once it went into my body, it would warm up to 98 degrees, and that's pretty warm as it is. Should I warm it in simmered water?
Never use water, use a blow dryer or heating pad.
Byanymeans78Warming 100% helps. I'm running test e from a good lab but it's thick so all I do is run the vial under hot water for about 30 sec to a min(I pre load my shots the night before) then right before I inject I repeat the process but with the syringe and it's worked great.
And it minimized the PIP?
Byanymeans78Haven't experienced any.
Byanymeans78My bro science idea is since it's thinner going in it disperses through the muscle easier vs injecting thick and it going all to one spot
TricepatopsWarm it up and touch vial with lips if it burns lips to hot to inject. Want it warm but not to warm. When done put hearing pad on it but do not massage the area. You are going to have some pip with 300mgs of eth. To me I get more pip with that ester then cyp.
Rustyhooker^^^^^^this
Click my avatar....read my warming forum