posted Fri, 05/18/2012 - 14:51
1534
Mixing Gear
ad
This maybe sound daft but we're all here to learn. Right guys can I mix Test e with Test p and would it be ok in Vial to sit for each pinning.
- Bookmark
- 0
- 0
can i mix test-e 250 mg of it...with boldenone....300 mg of it?? would it be too much?
AnonToo much what? Volume? Only 2mls you can toss that in your delt.
They mix well
thanks bro lol....all i need to know i never mixed before...but if i mex test with EQ i was thinking it could altern the effects....im stupid
AnonToss it in one pin, you can mix ALMOST any two oil based compounds together.
Heating with a blow dryer will help lower the viscosity of the oil, easier pinning and displacment in the muscle.
If your prop is painful you could shoot ed, more pinning but less hormone per shot or add some sterile oil (if on hand) to each shot. You can also split your test e dose up into more frequent shots, mixing with prop each time.
I didn't know about splinting the test e up into more frequent shots that sounds better. I started my cycle with test p which I pinned eod to kick me off then I started some test e. It's not giving me the same results so I'm looking to add some test p again. What you think?
I would just continue your EOD w prop and test e once a week.
AnonHow long have you been running the E?
Third week I normally feel the rise in strength by now but it mild was stronger at the start of cycle
You probably could but why? Prop is eod shot. Wouldnt be as effective. Problem two...what if you're allergic to one of the oils? You just lost both. Its a waste in my opinion. Long Esters are used differently. Thats why you have two types. Or go buy sustanon so it works properly in dosing.
ImTestyI know its ok to mix test e with test p in same syringe and pin..I know this because I did it on my current cycle...not sure if that's your question.you wanna know if can sit in same vial? I'm not positive but there are test e/p blends out there but not sure if that's the Same thing!!
When you were mixing it in the barrel did you heat it up to mix it evenly. The test p I have has a bit of spicy pip. What results did you get off using both together bro
ImTestyI did prop eod and on days test e and p fell on same same day I pulled the test e in the syringe then pulled test p capped needle heated the barrell and switched pins and pinned...would recommend mixing in same vial though...and if test p has bad pip could always cut it with something try and smoothin her up
Yip it was just for days they landed together. I never pin 2ml all in one I split so it was for clean even mix