posted Sat, 05/23/2015 - 14:39
1511
Concentration vs volume?
ad
Hey everybody, this is just a question I've had recently, and with my upcoming cycle I'd like to hear everyone's opinions on this.
Say you were incorporating a short ester into your cycle, such as acetate or propionate, and you'd be injecting EOD, at 100mgs.
The question is, would you rather have your gear at 100 mg/ml or 50mg/ml.
100mg/ml is 1ml
50mg/ml is 2ml
I ask this because I dont mind putting 1ml into my delts, but not 2ml, which removes 2 possible injection sites from the rotation.
Thanks for your input
JAG
- Bookmark
- 0
- 0
RustyhookerCan be a huge difference. Read any pip forums? There's hundreds. High dose is awesome if you know math and blending.
https://www.eroids.com/forum/general/general-talk/so....you-got-pip
opticxIm catching up to ya!
Thanks everybody, I'll ho with 100mg/ml for now, and cut it should need be.
higher less volume works good for me
I would prefer lower concentration and higher volume. Then again I have no problem with 2cc to the delt.
The less oil I have to pin the better. Even so, I still would not use the super concentrated gear like 200mg/ml prop or 500mg/ml test. I like pip even less so I stay away from that stuff.
I like higher concentration gear. You can always cut it if it should ever be necessary. But with low concentration gear you don't have much flexibility - certainly when it comes to site rotation for sure.
If the higher mg compound doesnt irritate you or cause unbearable pip then go with the higher mg. I would think the higher mg/ml oil would disperse throughout the blood a bit quicker, but Im not sure.