posted Tue, 05/28/2013 - 14:53
1335
Gear Temp B4 Pin?
ad
Doc has me on 1.5 ml test c very 2 weeks. He recommended running the test under hot water before injection. I've though about using a heating pad instead. good/bad idea? Not needed? Will higher temps damage test c?
- Bookmark
- 0
- 0
Sigh....if you're heating your vials/syringes in water, STOP! Use a dry heat source. Do you know how much bacteria is in water? You want to inject that shit in your body?
cbrant10I know for test p it helps slow the crystalization because of the boiling point but since you are injecting a long ester it shouldn't hurt as much.
No1I just dont see how it would make a difference, the oil will become heated as soon as you inject it in your body, maybe im missing something but it just doesnt make sense to me
I think the idea is that if it's the same temperature as your muscle where you're injecting it, you'll hardly feel it going in. That's how it feels for me, but I haven't tried not heating the oil.
Was a little pip at first but the test c is knocking the sand out of my vag, so no worries now. Thanks, Bros.
Personally I put my vial in a bowl of hot water for about 10 minutes, draw with a 22g, switch that out for a 23g, and then I run hot water over the capped syringe for a few minutes before I pin. I'm using test e and I don't think it hurts the test at all. I'm not sure how much warming it up helps though, I haven't tried it cold (my first cycle).
cbrant10The reason you do this is to lessen the pip but test c doesn't have bad pip unless you have virgin muscles. But it doesn't hurt to run it under hot water. Just warm the syringe and not the needle. Run it under hot water for about 20-30 seconds.