posted Thu, 01/25/2024 - 05:16
691
Test Cyp questions!
ad
Hey so I just got my test cyp in the mail and it was very cloudy….but they say it’s from the cold weather and shipping….on the box it said to shake and run under some warm water and that should fix it and dissolve the crystals formed….also online everyone was saying that…only problem is I did that and everything got fixed besides the crystals…no matter what I do I could still see crystals floating around in there….i think it may just be that the test doesn’t really mix well with the carrier oil but idk….what do you guys think….its clear….just little crystals everywhere in it
I pinned no problem….barely any pip
- Bookmark
- 0
- 0
Thanks everyone…this really helped…I would have kept injecting….you guys are sick…now I’m ready to get huge this cycle --
Just got some test cyp a month ago and it is crystallized. I put them in with my stash and figured I would address the problem when I need to with a heating pad. My question Makwa, does it need to be done right away or can I wait on not for a bit. Thanks
I just let them sit until ready to use. Not going to hurt them.
Awesome, thanks bro
I didn’t have a heating pad so I used the bowl of microwaved water…I’d leave it in for 5 mins, take it out and swirl, and repeat u til crystals were gone…it worked….just to be safe I’m gonna do all my vials tomorrow….dont want to chance anything
wrap it up in heating pad or put on candle warmer. Dry heat is what you want. Water harbors microorganisms and you don't want that near your vials.
Don't pin until it is back in solution. You know what you just pinned, mostly oil. Those crystals are all the testosterone
Now your dosages are going to be off since you pulled the oil out of the vail and left most of the hormone behind.
Thank you for sharing this info
Facts I only did one pin so far so it’s not like I been tanking the vial lol….only 1ml
Like makwa said, a good work around is to wrap the vial in a latex/nitric glove and let it sit in extremely hot water that way no water touches the vial hope this helps
In essence you could have pulled 10% of the carrier oil out leaving the hormone behind. Now if you had 200mg/ml Test C that has now become 222mg/ml for the remainder of the vial. The other issue is that by pulling out the carrier oil and some of the solvent you now have a more concentrated solution left that may be harder to keep in solution without crashing and may also produce more pip since there is more test in each ml now. Not an ideal situation and easy to avoid if you have future vials that are crashed.
You can microwave a small bowl of water take it out of the microwave and put the bottle in there. Make sure the water level is a third of the way covering the bottle and let it sit. That should do it.
Ive had that before, put it in a pot of water (midway up the height of the bottle) on low heat. Swirl the bottle every once in a while until all the crystals dissolve.