Introduction

Injections can be stressful for some; so to ensure this process is as easy as possible I have created a step-by-step guide on how to inject. This is a complete guide which includes the aids you will need to have pre-injection, during your injection and post-injection, while also recommending methods to prevent PIP (post-injection-pain).

Here's my injection guide' roster;

+) Introduction
+) Pre-Injection Aids
+) Intra-Injection Aids
+) Injection Preparation
+) Injection Procedure
+) Post Injection Aids
+) Conclusion & Recommendations

Pre-Injection Aids

~ Vial or Vials of Peptide Compound(s)
~ Syringe 1ml
~ Drawing Needle/Pin 27g/29g
~ Injection Needle 27g/29g/Insulin Pin (are all acceptable)
~ Alcohol Wipes
~ Sharps Container

Intra-Injection Aids

~ Warm water
~ Towel
~ Bowl

Injection Preparation

All your peptides should be stored in the fridge or freezer to prevent degradation. In preparation for injection, remove the peptides from the cool environment and place on a clean worktop so that it is ready to be pinned.

Once the vials are ready, dry them with a towel (and flip of the cap if the vial is new/unused). Next, take an alcohol wipe (1 for each vial) and wipe the tops to remove and bacteria or any other dirt which can cause an infection. Then, remove the syringe and the 21g needle from their packaging and attach together (some screw together, others need to be pushed together). Then inject the amount of air into the syringe to equal the amount of liquid you will be withdrawing from the vial to make sure the pressure within the vial is safe (if you are drawing out 1ml of AAS from the vial, then inject 1ml into the vial - this will also make drawing the liquid AAS compound a lot easier). Place the cap on the 21g needle and un-package the 29g and attach to the syringe.

If you need to reconstitute the peptides, I have a list of step-by-step guides available w/Pictures!

How To Reconstitute hCG Peptide (Step-by-step guide w/Pictures!)

How To Reconstitute GHRP-2 Peptide (Step-by-step guide w/Pictures!)

How To Reconstitute Mod GRF (1-29) Peptide (Step-by-step guide w/Pictures!)

How To Reconstitute Melanotan-2 Peptide (Step-by-step guide w/Pictures!)

I then select the site I am going to inject (you have selection of blue areas shown in the picture);

Injection Procedure

The image above shows the places on your body where you can inject into SubQ, select a site and follow the step-by-step guide below;

1 - Use an alcohol swab to clean your skin where you will give yourself a shot.
2 - Gently pinch the skin and insert the needle in through your skin at a 45 degree angle.
3 - After you insert your needle, completely release your grasp of your skin.
4 - Gently push down on the plunger and inject.

Post-Injection Aids

Shower - Once you have injected, take a shower and massage the area to disperse the liquid for faster absorbtion and minimal PIP.
Heat Pad - Apply a heat pad to disperse the liquid.

Conclusion & Recommendations

Always follow the safety precautions with every single injection you do. Make sure all your apparatus is disinfected and sterile and take your time when you inject.

Any comments, queries or issues on the topic of injecting can be discussed below