posted Tue, 03/26/2013 - 18:59
1429
Trouble pinning??
ad
The last few times I have tried to pin I have been unable to get the liquid out of the rig.. I fill it up stick it in and it is locked up, won't move? Very strange.. Anyone have any suggestions?
- Bookmark
- 0
- 0
I find that if I let my pin sit for a minute after I have pulled my gear from the vial then the plunger sticks kinda hard when I first start to inject. My two cents. lol
With water based drug like Test Suspension or Winstrol it will clog finer gauge pins up.
Try a 22g and see if that works. I had some Test Susp once that I had to use a 20g. Not fun
injections but Test Susp gets you strong and big quickly.
I just tried it again and same thing.. so I pulled the needle out and tried to figure out exactly what the problem is... well, figured out the problem but not the solution.. As I am sliding it in, something is getting caught inside the tiny hole of the needle.. I tried it 5 times and same thing...The hole is plugging up? skin? fat cells? The last time I only pushed it in 1 inch and it plugged up? Bad needles?
yes, I can push it out, but with a lot more pressure then seems would be needed. it is like something is clogging the needle passage as it is doing into the muscle? I just tried it with some test suspension so I know it's not the thick oil.
Can you push the oil out when the needle is not stuck in you?
Well I just tried it on the other side and same thing. When I pull the syringe out it's like vacuum locked? When I slide the plunger out a little bit and let go it snaps back to where the rubber seal is touching the liquid? I do put the same amount of air in the bottle that I am going to be pulling out with liquid.
Thanks guys. Most likely scar tissue. I have just been doing it on my right glute. I will switch over to the left and I bet that will take care of it..
Possibly scar tissue. Happens to me every now and again. I usually bury a 1.5" in the glute and if it happens I pull it out 1/4" or so and try it. If it still does it I change needle and re-pin in another location.
it is a 23 gauge with Test C.. The plunger locks up once it is in the muscle/won't move.. when I pull it out it is like it is vacuum locked. Very strange
what size gauge is your needle? are you pressing down hard enough? heating it up will let it flow smoother but you still should be able to inject it. are you using a higher gauge/insulin type needle?
Obama BlowsPersonally, I use a 23G needle and fill it up with oil and then hold in under running hot water till it;s nice and warm. then i swap out the needles for a fresh pin and i've never had an issue.
Run the oil under warm water to thin it out a bit.
Btw... What size pin are you using?
I think he's saying he cant get the oil out of the syringe into the muscle. Like they've already said, heat the oil, and get a larger gauge needle.
I am using a 23 gauge, with test C.. and once it is inserted into the muscle the plunger is locked/won't move. I will try heating it up but it's like there is a vacuum lock on it? very strange.. I have been pinning for 2 yrs now and this just started happening
StevebScar tissue, use another injection site.
are you injecting air into the vial?
what size needle are you using? what type of gear are you using?
Heat your oil.
^X2 flows real nice and feels good in the muscle
StevebWhat gauge are you using? You can't get oil out of the bottle into the syringe?