posted Thu, 09/28/2017 - 22:23
1236
Test suspension question
ad
It’s been a while since I had test suspension and I remember it being kinda milky white . Is it normal to have bottles that you can see the whites particles floating around in the water? Looks like snow in a snow globe . Also some bottles have accumulation at the bottom that just will not break apart no matter how long I shake it . Just want to find out if this is normal for test suspension as I don’t remember it this way . Thanks
- Bookmark
- 0
- 0
Love me some aqua test. Just shake the shit out of it. Draw and pin. Shouldn't need to heat it. If the pin clogs a bit pull the plunger back and continue pinning. It's gonna cause pip just get used to it. The stuff I use now I can draw with a 23 and pin with a 25.
BOGI love water base test I use it with most of my cycles because I see great gains. I have had that problem before with water base test no matter how hard I would shake it and how long it just wouldn't hold. I didn't see anything from that test at all and that's a product that work magic for me.
Normal, heat it up a bit(only in hot water) and shake it very well before you pin. Use a thiner needle for drawing the liquid so the particles don't go in the syringe.
Aren’t the particles what make up the testosterone? The particles can be filtered out and you will still get a full dose ?
No just a byproduct from the raws
Don't you just love old school suspension?
This is a common occurrence. Shake that up vigorously. Also , as suggested , you can run the vial under some warm water and continue to swirl and it should be good. Ive also taken multi-dose vials that have a few doses taken out and inject some b12 to help break up settled particles with more water volume.
Would heating a water base product make it more susceptible to bacteria ?
no
Water based Test will look like that I've never had it clump where it would not resuspend after shaking .. do not heat it it's not going to dissolve like it would in oil ... if it won't go back into suspension after shaking then pitch it cause you won't get a accurate dosage
I haven't heated, just gave it a swirl and it pinned usually without issue through a 25ga. Couple clogs but a little jiggle on the plunger cleared them.
If you don't like the water based you can always try oil based, that stuff will slide through a slin pin.
Ive used it a few times i always used a blower dryer to heat it up and like ppg said had to shake the holy hell out of it
I've only tried suspension from two different sources. So I'm no expert in the matter. But yes both of them I needed to warm up under hot water and shake for a long period of time. Neither one ended up never going in very smooth and I would be left with white powder in my syringe.
Merces33letiferfrom what i just googled, the test is suspended when shaken. heat up the amp or vial with water and shake it.