posted Wed, 05/16/2018 - 17:26
3125
Primobolan's Maximum Milligram Strength per ml ???
ad
For many years I was told that the maximum producible strength of Primo is 100mg/ml. Supposedly it has something to do with the molecular weight of the methenolone compound. Regardless, some of the UG labs has been offering 150mg/ml and most recently even 200mg/ml.
Can someone who really understands the chemistry behind all this comment on this issue. Thanks.
- Bookmark
- 0
- 0
JayD718I've also used Primo 100mg and 200mg, which was made by a very popular and reputable brand, and equally reputable, very high ranking source on Eroids. It definitely did it's job, and you could really tell the difference in effect, from the 100mg, and the 200mg. However, in regards to PIP, there wasn't any noticeable difference. Producing gear that is double the potency, yet in the same amount of oil and solvent, I think is obviously due to new, or different solvents and carriers that weren't available years ago.
It can be brewed at 200mg/ml like the other lads said , like test being brewed at 500mg/ml , when labs first came out with test that was brewed at 400mg-500mg/ml or I recently saw 600mg/ml a lot of people thought it wasn't possible to brew it at an mg/ml that high but it can be done it seems.
Pharmacy grade is 100mg per ml
Ugl can go to 200mg per ml thus far
Google "solubility".
In layman's terms a powder will dissolve at different rate in different solutions,...... or,...... change the carrier oil to change the mg/ml.
There was a lab that,retired,he had 200 mg primo and anaboliclabs tested it at 201 mg.Therfore you info is not correct.
I don't know about the chemistry either but will say that I've run 200mg/ml with no pip from a ugl that's long gone. I've most recently run 150mg/ml with no pip either... both were excellent cycles.
Really? I’m surprised. I heard the asian sounding lab that makes 200 has a bite to it so I just assumed. Sure would be nice to only have to run 3 cc a week.
I have ran several labs at 200mg/ml and none had any pip. Without it, I would not be doing any primo cycles. Way too much oil for me to pin otherwise.
I know which one you're referring to but never tried it. The 200mg I was referring to came from the top source here about 4-5 years ago and it was smooth... no pip whatever. Made it easy to pin a primo cycle
No idea about the chemistry but I know it can be brewed pip free at 150 mg/ml. I think 200 is where you start running into issues with needing more solvents and resulting in a lot of pip.
The pharma amps are 100 but they also use something like molasses for the carrier oil. Such a pain in the ass to try to pin through a 25 ga. My point is that pharma is not always best, if a ugl can produce 150 mg that I trust in a nice mct oil that’s far preferable.