Anonymous's picture
Anonymous
  • 0
4418

Pinning Issue / Cork

ad

I require some assistance please.

I'm currently pinning 1ml of EQ and 1ml of Test E (same syringe) 2 x per a week.

As an experienced user I'm very familiar with my body and how to correctly inject, however I'm struggling to get use to injecting 2ml. I usually only do 1ml per an injection site.

I'm experiencing HUGE amounts of discomfort about 12 hours after each injection into my glutes, the cork is crippling. I am literally almost unable to walk, sitting down is near impossible and bending over is out of the question. I have never in my history of usage had some a negative affect after an injection. The worst thing is it takes about 6-7 days for the pain to subside to something more tolerable.

I'm drawing 1ml of EQ and 1ml of Test E through a 19g needle into a 5ml plunger. Originally I injected my first 2ml with a 23g needle, however I found it to slow and awkward. I decided to inject my 2nd 2ml into my other cheek a 3-4 days later using a 19g needle. This was allot easier and allowed me to get the job done better. However, once again I was almost on the ground about 12 hours or less later.

Currently I have injected 4ml, 2ml into both glutes. Have people ever had this problem before? I'm pinning in the correct area, using medical grade pins, plungers, alcohol wipes, warming the oils in warm water etc. I've followed standard procedure. The glutes are supposed to be fatty, soft and wobble when you massage them. When I massage over my injection site it's almost like touching a brick, my glutes are tight, and firm which isn't a good sign. I have about 15% bf as well so there is plenty of meat on.

The reason I'm passing this info on is I'd like to continue my cycle. The worst problem is I'm unable to train properly, absolutely any exercise that involve my legs is out of the questions, dead lifts, lunges, squats, cardio... you name it.

Products Used:
Signature Pharma EQ 250mg/ml
Anabolic Nation Test E 500mg/ml

levelup's picture

it could just be the high mg test e....but try popping a couple advil or aleve and see if it doesnt anything for the inflammation...and fuck a 19g. other than that try to heat it and stretch before you train the ice afterwards

In a promo × 2
Makwa's picture

Inject sloooowly. Using a 23 or 25g forces you to inject slow. Should take at least a minute or two. Squirting it in there to fast can traumatize the muscle tissue. Have you tried a different injection site like quads. I can't pin glutes very effectively. To akward for me and the needle ends up moving around to much causing pip.

cry_havoc's picture

Heat the oils in hot water or a dryer and use the 23. It should take about a minute to inject. Nice and steady and your forearms will get a pump from pushing the plunger so hard but that's the best way to inject oils.

mhman's picture

Have you used SP and AN gear before with little or no discomfort ? If not, perhaps its the base oil since there are various types ( EO, GS,SS, ect..)
Also, a 19 ga pin is like getting harpooned. 23 ga should do just fine, heat the oil up w/hair dryer for better flow.