posted Thu, 01/05/2012 - 06:13
2924
kigtropin vacuum
ad
it's normal that the vials of kigs from Haidee are without the vacuum?
Any experience?
Thanks
- Bookmark
- 0
- 0
it's normal that the vials of kigs from Haidee are without the vacuum?
Any experience?
Thanks
Not sure about a bad thing but I've never had to put air in mine
Yeah you need to be careful when that happens, make sure you let it go in slow and try and drip down the side of the bottle
Usually you don't need to put 1ml of air in it. When you stick that 23 in there it should suck the water right out of the syringe, you usually need to hold the plunger back
mine are without vacuum at all! And I don't feel any effect of the product.
she spoke with the technician of the company and told me that it's a new method that implement the use of N2 to keep the powder safe in place of the vacuum, so it's ok
no vacuum at all also with 23g!
tread-mOk contact the supplier, I think youvsaid it was E? They are very prompt in resovling your issues. I have an email in myself to address it since I use them too. I am hoping we just got a batch that had seal issues which I am beginning to think may be the case. I have confidence in the source though so I don't see you having any problems gettig it replaced. Keep us posted on the issue please...
Out of interest I filled an ehealthpill Kigs HGH vial using a 29g insulin syringe. The plunger pulled in under the suction of the vial real nice and steady without the need to apply pressure. So I can say the you should be able to feel the vaccume drawing it in. As bailey says the grey rubber stopper should also be indented due to the negative pressure inside the vial. Speak to Heidi I'm sure she will sort it. I have found their customer service second to none.
many thanks!
tread-mHad one other question about this. If mixing with a gear pin it will try to suck in the water and if using a slin pin it may not so think of that. If yours do not have vacuum you need to notify her for an exchange.
All mine have sucked with slin pins from her
tread-mMay be the brand I use is tighter. My gear pins (23's) will suck straight in on their own witbout touching them at all, my insulin pins are tight and I actually have to push them in just a bit.
i have always used the ones from getpinz they only have 1 kind of slin pin i believe.
thanks for the reply, i use a 23 g pin but no vacuum at all! with other products I used the vacuum was pretty strong I'm a little worried.
Have you got good results with kigs from haidee?
Look at the rubber vial at the top it should look indented (as if it were being sucked into the bottle). Every kig i got from haidee has been vaccuum sealed pretty much by 2cc's meaning in order to suck anything out i would have to fill the bottle with 1cc of bac water then another cc of air just to create a balance in air pressure.
To make things easier now i just put my 1cc of back water in then completely pull the stopper out of syringe itself (leaving the needle and syringe in the bottle without the plunger)then replacing the plunger thus pressurizing the hgh bottle by 1cc. By doing this it evens out the pressure both inside and outside the bottle then adds pressure inside the bottle so i can easily pull out the amount of hgh i need.
There are also a few times that i dont exactly hit the middle of the rubber stopper and it wont suck up the back water giving the impression that there isnt a vacuum.
I been using kigs for about 6-7 weeks now. I have only used 28g and 29g slin-pins until recently I had to use a 23g and i had to just touch the top barely and it sucked it all in but way to fast I think so wont be doing that again. But with the 28-29g pins works perfect sucks it in and can make it just drip down side and not spray in. I have seen like one or two of the vials that the rubber stop was a little rough looking on the top but not to the point of not being air tight.
Depends on what size needle your using. If your using a 28g, and other sizes but I've only used a 28 so i can't vouch for other sizes there will be no suction but if your using something like a 23g then yes there should be