Ok so you have your gear and your pinns now your ready to pin AAS, so you take out your syringe take the cap off the vial and draw up your 1cc and into the muscle it goes.. AWWW that wasnt bad actually felt pretty good. 24 hours comes around your injection site is red swollen a little painful, day 2 its really red swollen and the area has become extremely painful. day 3 and now your freaking out wondering what to do becaus enow you realize something is really wrong here you realize( i have an infection) lets go over basic steps and procedures to help prevent or minimize the chances of an infection when using AAS.

step 1.. make sure you have new sealed syringes and needles attached, with a box of fresh sealed pinning needles .

step 2. use rubbing alcohol on a cotton ball and swab the are where the injection will take place.also make sure you swab the top of the vial as well and let both AIR DRY 30-40 sec.

step 3. unwrap you syringe and uncap the needle draw 1 cc of air for 1 cc of oil insert the syringe into the vial push the air in then draw out your AAS pull syinge out and cap it.

step 4. unscrew old needle that you drew the AAS and replace it with a fresh needle uncap insert into the part of the body you swabbed with rubbing alcohol empty the syringe waite 30 sec and remove.

step 5. dicard all sharps into a container so nobody pokes themselves.

if at all possable its best to shower before steps 1-5 if this is followed everytime this will greatly reduce your chances of getting an infection.

BUT MOST IMPORTANT USE A NEW NEEDLE EVERY TIME NO EXCEPTIONS !!!!!!!!!!!!