MY VERY OWN Test P, NPP, and Masteron Blend
How would I go about making my own blend, consisting of Test P, NPP, and Masteron Prop? My next cycle I am wanting to run these 3 compounds, but I want to avoid drawing from 3 different vials every time before I inject.
Each one of these compounds are 100mg/mL each, I suppose that if I were to mix them all together in 1 vial the mg/mL ratio would drop down to 33.3mg/mL. Is my math correct? If so then that means that if I were to inject 1.5mL of this blend it would balance out at approximately 50mg for each Test P, NPP, and Mast P, is this also correct?
With all this said, I would also like to add I have never been much of a chemist. So once I mix 1 10mL vial of each compound into a 30mL vial, what do I do? I want some expert knowledge on this.
Thanks ahead of time...
- Bookmark
- 0
- 0
so does this mean i cant draw 1ml of prop into syringe and them draw 1ml of e into same syring and pin?? cause i have done that??? was i wrong?
So guys I need to know, do I need to heat/low boil the mix so the compounds are evenly mixed once I have them in 1 vial?
The only 30ml vials I have on hand are the 30ml bacteriostatic water...but they are plastic, and I don't know how the gear would hold up in plasic bottles.
Certainly would be more convienient to only have to inject once.
3mls of each compound into a 10ml vial = 9mls of mixed compounds
That is true, but 3*10mL vials=30mL so a 30mL vial will work.
Yea it would save time, also 1 vial is easier to hide than 3 vials. Would I have to heat the vial once I have them all mixed into the 30ml vial, in order for the compounds to mix evenly?
P.S. If you look under my rated sources one supplies 30ml glass vials.
I'm not sure you would have to heat the bottle, but I wouldn't shake it.
Aite I guess I'll just mix it and stir it up a bit, and see where it goes from there.
Nasty81NateThere's 30 ml glass bottles online for sale, they usually come with one of those dropper caps though.