posted Wed, 12/27/2023 - 05:49
3307
+ 3 Teamroids promo / crashed
ad
Teamroids promo just hit today. 4xNPP 150. Two crashed. Any advice on bringing it back??
Ordered from:
- Bookmark
- 3
- 0
Heating pad, wrap them up, put it on low and they’ll come back. If there’s any doubts kick it up to medium.
What does crashed mean?
Turn on coffee maker. Set vial on that hot plate. Swirl in bout 5minutes but use glove or oven mitt
150mg is a great dose. But it will crash
Ya see, that when a Keurig sucks, LOL
Agree. Very tasty but expensive too. The office Keurig is in constant use.
Yea I remember @Jockstrap referring to hot coffee plate method a long time ago. I think that's where you got that from @JakeKO. I never thought of that but I prefer water method
Yeah, @Jockstrap mentioned the coffee maker hot plate a long time ago. I have a damn Keurig, so I went on Amazon and bought a $10.00 coffee mug warmer. Shit works awesome. I mix whatever I’m pinning in an empty bottle and leave it in the warmer for about five minutes and it’s ready to go. Although, then you gotta use his baby bottle testing method to make sure the barrel ain’t too hot, or you going to get a hot shot from hell. Fucking strangest feeling I ever got. I would have hit the floor if the bed wasn’t right there, LOL.
Ya see that Shit, Russ, I definitely learned some good shit from you, LOL
Damn lol. I might try it. I'm just use to the old school water method. Can't get it too damn hot though, just hot enough to liquify any crashed or small crystals in oil.
Or
I use these methods for all my crashed gear and never experienced Any Pip afterwards.
Don’t use water method
Water method shouldn't be an issue if tops aren't covered with water. Alot of folks don't seem to have an issue with this method but to each their own.
There are just more effective methods without the risk of contamination. Other methods eliminate risk.
I’ve used the oven method and put 25g pins in the stoppers as a vent so they won’t explode
Agh, forgot to mention that.
I've always put vials on a towel so the stay put, then heat them with hairdryer and they have turned back into solution for me. Never had pip issues
I would ask the source to send you two new bottles or you’re in for some wicked PIP. Some people heat it up and inject it, but I feel it crashes in your body after injection like I think it did to me, the pain, swelling, abscess will be excruciating.
If you must reheat it, I’ve found a coffee mug warmer to work best. That’s how I heat all of my oils prior to injection
My crashed gear was not from this source though
Was wondering if the pip was gonna be bad. Cold snap here. If they were to send out two more I could wind up with 4 vials crashed that way. Don't want anyone really going out of their way for me especially when it's free n all ya know?
Like I said, some people warm it and are fine. Every time I’ve done it has been very painful. Ruined cycle type painful. I can’t pin volume higher that .5cc to anywhere but the glutes, so I was screwed on every occurrence
Yeah I remember when you told me about your experience. You had dhb though right? So that's even worse.
Might not be as bad as you think. Just heat up those vials as described and if you get pip then contact the src. But yea like you said, it's free so I see it both ways.
Yeah candle warmer is working I think
Good deal. This the thing though you gotta completely melt the hormone cause it's crystallized good. Npp melting point is around or a little less than 200 degrees. Shake vial off and on.
Hot water bath in sink. Fill sink with hot water let the vials sit for 15-20min. Shake vigorously. Repeat if crystals don’t disappear repeat again
Very dangerous method bud. Water can potentially get in, which a recipe for an infection or worse. Never submerge vials or let the top near water.
I'd go with Simon's methods above personally but if you want to heat water, do it with a small amount od water in something with a flat bottom so there's no risk of the top touching the water.
As an aside, NPP over 100mgs/ml is very prone to crashing so I wouldn't ask for new vials because they're likely to crash as well. Especially common during cold seasons.
I didn’t mean cover the top of the vial. Just enough water to cover half way and keep the vial standing up
Gotcha. Just wanted to clarify bc some may have misinterpreted.
Heating pad
I just had this happen to me with another brand of NPP150, I've tried various methods of uncrashing high mg NPP's and Test Props over the years and my favourite is still 50 secs in the microwave (900W)
It stays suspended from then on and the hormone still feels and acts the same.
No sparks from the metal top. I left a fork in there one time and it caused a lightning storm in there
Seriously bro - never!!! I figured it would do it but never has, I think some microwaves don't do it.
Apparently it's to do with the shape of the object and how smooth the surface is. Smooth and round objects don't spark as much.
Thanks for finding that out BFG!!
Maybe it is the wattage. I heated up some coffee in a mug the other day and the damn thing starting sparking and popping. The logo on the mug must have had some metallic paint or something. Mug was burning hot and the coffee still cold
I think its because the metal or whatever the stopper is made from is so small and thin that it doesn't cause problems with the radiation. Seriously mate - bet ya $10 right now if you go try it won't spark!! Lol
Bro you can't put a gum wrapper in a microwave without fireworks?!?
They do weird things for entertainment in the UK
Lol. I agree
Hold on hold on you don't even have my cash tag to send me the money when I prove you wrong!
Tried it yet mate?!
Haha nah bro candle warmer raised her back from the dead
Was just thinking that?!?
Hell nahh. Learned my lesson from that long ago.
Damn that's a solid crash. At least we know there's crystalline hormone in there. Don't get vials too hot now. Glad this pack wasn't stolen from your porch.
Broooooo I'd have snapped today!
Ha I bet
I use a skillet on low
With a little water in there or what?
Just place the vials on top of a skillet low heat , for a 1-2mn
It's that time of year. Wrap them up in heating pad.
Yeah figured you'd say that @Makwa