themanmas's picture
themanmas
  • 46
983

test e and prop vs test e and eq

ad

Trying to figure out a 4th cycle what are your guys thoughts

Test e 500 week 1-12
Test prop 100eod 1-4 and 10-14

Or
Test e 600 week 1-12
Eq 500 week 1-12

Looking for lean mass of course diet will be in check any advice will be great

UncleYoked's picture

I don't see the point in running test e and test prop together for that amount of time. Test e and eq will add mass but it may not all be as lean as you like and eq really needs to be ran for a minimum of 15 weeks for optimal results. Youre already thinking about running test prop, just drop the enth and add either mast prop or npp. Run all short esters this cycle. It's your forth run and are probably ready for ed pinnings. Would look something like this.

Test p 75mg ed
Npp 75mg ed
Aro 12.5 mg eod
Caber .5mg e3d

If you run mast prop instead of npp you won't need any caber. Are you set up for your pct?

themanmas's picture

If I do that how long will you run it for and I'd probably stick with eod crazy work schedule/job I know you can run prop eod

UncleYoked's picture

10-12 weeks. Whatever you're preference is. Eod pinning is fine with those compounds. Pct will be the same no matter what compound you run. Give it time to clear your system before you start your nolva and clomid. A lot of guys are running aro through pct as well to keep estro levels under control just like on cycle. I'm TRT so no more pct for me. You'll have to read up on incorporating aro during pct to be sure you know how to run it.

themanmas's picture

How would pct be since npp is in the mix never ran 19nor

themanmas's picture

28 now 223-225lbs bf at 14% ran ran three test e cycles one with winny one with dbol one solo all 12 weekers and that one for November got pushed back that's the one I'm getting ready to be running now I'm been dieting now and plan on running march 1st when bf %s lower and I'm looking for clean gains

P's picture

Stats
Age: 27
Height: 5'9
Weight: 23????
BF: 13%

Full cycle history with layout?

I can already see a few changes i would like to make to the cycles for lean mass, but before i do this i need to know the above information.

EDIT>
Are you sure you want lean mass, in November you were asking for a clean bulker...