posted Fri, 01/20/2012 - 21:35
1667
Gear will not pull into syringe
ad
I've dumped as much air as I can get into my vial, and still can not hardly pull more than a cc into the syringe. I thought my vial looked short so I was going to see how much was there, but I only got it to pull about 3 cc before no matter what I did I couldn't get it to pull any more. I am using a 23 gauge needle with a 3 to 10 ml syringe. Is this normal? Pushing oil back into vial was also very difficult and came out of the needle in very slow drops, not a stream like my b complex injections. Is this normal as well? Thanks crew.
- Bookmark
- 0
- 0
AnonHas to be something with the pin bro. I draw with a 25G and have no problems.. although, its slow as fuck!!
drip, drip drip drip drip drip lol
Have you only tried the one pin??? It could be a defective (partially blocked) pin.
Iv always used a 22 never had any problems with drawing
Bigger pin bro. Draw up with an 18. That will get it in there
10ml syringe ???
pi x RxR (square)= Area of circle, a larger circle will require more pressure on the plunger to achive the same pressure (or vaccum) in the pin.
tread-mBigger pin but still getting it warm in front of the hair dryer will do wonders. I even draw with my 23 and takes me all of. 30 seconds per ml. Having said so I'm not one of those that has to check if I have a perfect 10. If the gear is good and I get 8 then I get 8, I'm over it.
Thanks for the responses. It is test cyp, I've never cycled before so I had no idea it would be so goddamn hard to pull. I'll try warming it up until I get my order of 18's. Is it normal that test cyp will hardly push through a 23? I see some people are using 25s, I'm pretty confident that would be totally impossible with this gear.
If you're having this difficulty already then definitely heat the vial first and avoid glute pins (if you're having to push that hard eventually you're going to shake a little and then you have one hell of a sore, bruised (and probably bloody) injection site. Stick to quads and be patient.
dansta123i would say they are pinning it or clueless
What are you trying to push? I know stanazol can be a pain! enlighten us!
Or you could try heating it some.
Bro, try using a bigger needle 18-22 gauge.
dansta12318 g works every time,fuck that fine needle off for drawing..only to be used for pinning at that gauge.