Big ads's picture
Big ads
  • 26
1312

crystals in my gear

ad

Hey i have some bold cyp that i have been using recently i noticed loads of crystals have appeared in it, i was wounding what your thoughts are. Iv'e heard of people heating it but i'm not sure? Would you chuck it or is there a way of bring it back ?

Dacky's picture

I had one vile out of 6 of Bold Cyp that inexplicably crashed. All the same brand/batch and all store in exactly the same way (room temperature at the back of my cupboard. No matter what I did I could not get it back into solution. Binned it and the source replaced it for me.

Carlos Danger's picture

I had some super test shit that always crashed. I would heat it up and it would look great then a day later shit was crashed again. Needless to say I didn't have a warm and fuzzy feeling about pinning that shit. Good gear shouldn't crash when stored properly at the right temperature. Chances are you might have some gear that isn't holding. Happens to Brewers all the time.

Big ads's picture

Thanks for the advice guys !

irongame427's picture

bold cyp tends to crash, use dry heat, i put it on the stove in a pan for 20 mins on low heat swirlling it every 5 mins or so.

BigWA67's picture

I use a hair dryer on the vials when crashed always works for me

KING's picture

Just wrap it up in a heating pad for a while. Always works.

Makwa's picture