posted Wed, 04/17/2013 - 12:51
1084
Crystals in all myTREN E 200
ad
Been on for two weeks with no issues n all of a sudden as im about to draw some tren i see a big crystal stuck on the bottom of vial? Reputable source so whats the dilly?
- Bookmark
- 0
- 0
Heating the solution does rid of the crystals, but if the hormone hasn't been suspended in an optimal solution (adequate amounts of carrier oil, etc) then it can 'crash' again ones it's been injected.
It's personally happened to me. I tried using a new 300mg/ml test/mast/tren blend a few years ago. It must have been very recently brewed, because a day or two after injection, it crashed inside my leg. It was like walking with tiny fragments of glass in there.
If you really don't want that kind of PIP, heat it so the crystals are gone, then give it a day or two at room temperature to see if it crashes.
Then again, might not be a crash, could just be something in the solution coagulating.
Yea bro just heat it up and give it a light shake swirl
Heat it back up and it will hold... Well mine does.
melted it shot it got it!
You haven't been storing it in a cold area have you?.. the colder the more likely your gear is to crash
apparently that has to be the case...little heat in front of a heater n they are fading...still good to inject when they disappear?
Should be but pip might be a lil rougher than normal