posted Fri, 04/20/2012 - 18:22
1019
Crashed beyond repair?
ad
I recently got 2 bottles of primo from a good source, but they have flakes/crystals in them. I tried heating one up with a hair drier and shaking it up but it didn't eliminate it fully. Still looks like some snow in there.
Any suggestions? Ok to pin?
- Bookmark
- 0
- 0
Try putting it in the oven set on 250 to 300, Put a needle in the rubber stopper (but not touching the oil) so the bottle doesn't explode. That will dissolve it for sure. I had to do this to some winny I had that would not stay dissolved.
Also cut the plastic flair off the needle, but after that the plastic will melt and the rubber stopper will catch it.
FrankiePlace it on a hot radiator over night bro and see what it is like in the morning
Is it primo e ?
Dose per ml?
If its say 100mgs/ml 10ml vial then there will be 1g of raw powder in there ,if you got scales take a look what one gram of flour looks like and compeer it to what has crashed ,it will be likely a very small amount of the raw that has fell out of suspension so assuming that's the case it should be ok to shoot if you can't get the rest to resuspened , or it could be very underdoses and what raws that are in there have crashed leaving just solvents and oil as liquid and a small
Ammount of crashed raws but saying that enanthate don't really crash .
Trusting your source is a must when it comes to primo
thanks Frankie, its from pharmacom their primos 100mg/ml which is supposed to be enanthate... I ordered 2 to test them out before I went ahead with others - think I should consider alternate source?