posted Fri, 11/18/2011 - 04:31
2101
First time pinning roids
ad
Iv never injected steroids before, im about to buy 25g 1.5inch needles and 1ml injekt syringes, are these compatible? (both say luer slip), its to inject test c
- Bookmark
- 0
- 0
Anonyour 25s are fine but for drawing you'll want to use something bigger, the oils will take forever if you try the 25.. injections will go slower but the actual pinning will go real smooth..
I AM USING 25G X 1.5 ON GLUTES. the oil is thick and takes a bit to push it through but the pinningis so smooth that i dont mind. i have 22g x 1 i use for my delts as well. i have used one inch on glutes as well but like the 1.5. as long as you are getting into the muscle the gauge is about preference i think.
Eric090585I'd get 3cc syringes bro. cuz at some point you're gonna need to pin more than one cc. And I use a 23 gauge for glutes
3cc 23 gauge 1.5" in the ass and goes in smooth
Eric090585I use 1" myself
Nasty81NateWhat's your cycle plan bro....for glutes I run 22 or 23g 1.5" 3cc BDs. The 25g might be a lil too small if your oil is thick.
They are compatible, but the length and size of needles depend on where you wanna inject (which muscle) and not so much on what you're injecting.
You can find info on how to inject on this site : http://www.steroid.com/steroid_injections.php
But they're are many other sites just as good.
Also, as for the length of the needle, if you pin you quad, depending on you body fat %, you may want to use 1 inch or 1.5 inch, glute 1.5 inch, delts 1 inch etc..
Good luck bro!
hopefully only gonna be pinning glutes, should be cool then ill go ahead and buy, thanks for advice!