posted Mon, 03/02/2026 - 14:49
953
How would I mix test and primo in same vial?
ad
I can do this right? Inject test first than primo? Same needle since I use the insulin one
- Bookmark
- 0
- 0
Is this your first cycle bud
Hey Pete! Run those together a few cycles. Primo has a low concentration, thats why its a bad choice if you dont want loads of volume to inject. Mostly the 100 is most available and no PIP, so anytime you want to run high doses youll need to inject Daily to make the volume managable. So you go up to 500 youll need to inject 5ml that week somehow, practically daily of 1 ML. So another work around is a higher test volume to fit it in 1 syringe. So there is Test E400. It has PIP.....but....if mixed with the Primo it buffers it out. So for example:
.25 ml of TestE400 (100mg of Test) then put in your full ML of Primo (100mg of Primo)
Thats just 1.25 ml of fluid per day. Thats managable.
Or you can throw Mast in at higher concentration....
(I know a week is 7 days....in my head I look at it as 6 when it comes to injecting)
Why would you not just draw them separately
Hey Pete I sent a friend request too. I would draw separately but I don’t want to pin so much as I don’t have much spots to pin and in case of pip
Can you not just draw the required amount of Testosterone and Primo into the same barrel as you require them?
This fucker looks familiar...
This has to be a dumb ass
Step 1: get sterile vials
Step 2: calculate your weekly test amount and weekly primo amount.
Step3: Draw said testosterone amount
Step 4: Draw said primo amount
Step 5: Divide the volume amount by 7
Step 6: inject both volumes into the sterile vial
Step 7: stab yourself day with the volume amount that was divided by 7.
Oh fck me. Not same vial I mean same syringe lol. Like draw up test than draw up primo
You realize when you put them in the same vial. They end up in the same syringe right.
Fuck that was like algebra. I just
Step# 1, wipe all my vials down with alcohol
Step# 1-A, draw what I want into a syringe like I'm making cookies
Step# U, heat up the syringe and oil
Step# ¿ Switch needles and put it in my body
i do all this except switch needles. i just say fuck it draw from both vials 50 units of my test 50 units of my primo. heat up under warm water, inject (obviously wiping everything keeping sterile). turns out to 300mg test/week, 150mg primo/week. inject tues/thurs/saturday.
I switch needles because I draw with a 22ga and pin with 25. Also the water. I don't want any chance of pinning Midwest tweaker water into me. But yes other than that we are twins.
Fuck except you're young enough to be my kid had I gotten my first gf pregnant.. you're not a redheaded Jew are you? Fuck I'm old.
LMAO
Look at his past forums before you respond...
Damn I know I ask a lot of questions lol but first time
I can do 200 test and 200 primo?
Depends on your goals, current ht/wght, experience with those compounds. 200 is a bit low for both. Thats low-moderate amount for both. 300/300 is a good start, see how you feel after a few weeks. Judge progress, going up to 500 is fine, but youll need to tweak that test to primo ratio with some trial and error with your e2 and how you feel