posted Wed, 03/11/2026 - 16:33
732
+ 1 Crashed inj Anadrol? Help
ad
Before I trash this with the floating hormone in it, anyone have any tips? I’ve tried a candle warmer, pan with water and hair dryer. Nothing.
Key says just pin it and it’s fine but I’m sketched. Once it heated up hot as heck, I swirl it over and over and the floaters just settle at the bottom. None go away.
Ordered from:
- Bookmark
- 1
- 0
Get out cast iron pan, heat on high, place vial on pan. I use an infrared thermometer to keep the pan under 400. Works on Superdrol every time. Never has adrol come out of solution.
If you’re not into heating vials & such, I’d suggest not buying injectable anadrol, superdrol, test cyp, dbol etc.. this is very common.
Where did I say I’m not into heating vials? I’ve bought plenty of inj SuperDrol and anadrol.
Like I said I tried everything and nothing worked. Even after 30 mins in the candle warmer so hot I couldn’t touch it. Nothing. Shook it up and it had floaties
Candle warmer won’t get hot enough for anadrol, especially if it’s not loaded with guaiacol. Need to get it up to at least 100C, but likely higher, and a candle warmer tops out around 70C.
Superdrol goes in solution very easily with just your typical 18/2 BB/BA
Better make sure when you heat it that it’s fully dissolved. Ot will hurt if you don’t. Heat it. TIL it melts all the way. Crashed gear will be find when it’s reheated and melted again.
I’ve tried.. idk why everyone thinks I haven’t. No matter how much and hot I get it the crystals aren’t dissolving
Idk then. I wouldn’t inject it because it will fucking HURT. Go with orals
That’s what I’m saying! Not attacking ya. Lol I guess people got from my description I’m not into heating vials.
Yeah no matter how long I got it hot and worked on them they didn’t dissolve
BardockSounds like he just did not filter it very well that's a bit bothersome in itself
Fr sent....hit me up bro
Let me start by saying that I have almost 30 years of experience in the sector. I often find it annoying to write here in this forum because you only get attacked.
They are Anadrol crystals, not dissolved in oil. What problem would they cause? They won't be drawn up by the needle and you'll lose 1% of the product at most.
To dissolve any crystal even the most resistant in ester-free steroids, I use the following method:
I put the vial in the microwave and cover it with the plastic lid that came with the oven, I set a timer for 30 seconds at a time
I check if it is hot enough, I take it with a kitchen towel, because it will become very hot, and I shake it, they will melt easily, usually 1.5- 2.5 minutes of microwave time is enough, but to be exact then do steps of 30 seconds at a time, take it and shake, repeat the process until completely dissolved, I have never missed a shot
no heat will ruin the hormone
I tried explaining this in a shorter version lol....this is very typical of Adrol and Superdrol Inj. that don't have an ass load of Guaiacol or some other random super solvent to break it down. Definitely gtg
I have some of that coming but a different brand, hopefully not the same issue.
Injectable Anadrol and Superdrol do that a lot. Those are most likely bits of unbroken down Anadrol raw brother. Especially if he doesn't use something strong like Guaiacol to break it down.
Long time on candle warmer is last resort. It will prob nuke some of the test but its junk if it does go away anyway.
You can't nuke test away brother lol
Half hour on the candle warmer didn’t fix it. I think the trash it goes! Sucks!