Get out cast iron pan, heat on high, place vial on pan. I use an infrared thermometer to keep the pan under 400. Works on Superdrol every time. Never has adrol come out of solution.

If you’re not into heating vials & such, I’d suggest not buying injectable anadrol, superdrol, test cyp, dbol etc.. this is very common.

Better make sure when you heat it that it’s fully dissolved. Ot will hurt if you don’t. Heat it. TIL it melts all the way. Crashed gear will be find when it’s reheated and melted again.

Fr sent....hit me up bro

Let me start by saying that I have almost 30 years of experience in the sector. I often find it annoying to write here in this forum because you only get attacked.

They are Anadrol crystals, not dissolved in oil. What problem would they cause? They won't be drawn up by the needle and you'll lose 1% of the product at most.

To dissolve any crystal even the most resistant in ester-free steroids, I use the following method:

I put the vial in the microwave and cover it with the plastic lid that came with the oven, I set a timer for 30 seconds at a time

I check if it is hot enough, I take it with a kitchen towel, because it will become very hot, and I shake it, they will melt easily, usually 1.5- 2.5 minutes of microwave time is enough, but to be exact then do steps of 30 seconds at a time, take it and shake, repeat the process until completely dissolved, I have never missed a shot

no heat will ruin the hormone

I have some of that coming but a different brand, hopefully not the same issue.

Injectable Anadrol and Superdrol do that a lot. Those are most likely bits of unbroken down Anadrol raw brother. Especially if he doesn't use something strong like Guaiacol to break it down.

Long time on candle warmer is last resort. It will prob nuke some of the test but its junk if it does go away anyway.