300 Savage's picture
300 Savage
  • 0
1310

TNE keeps crashing?

ad

I keep getting crystals forming on the bottom of the 10ml vial..

Does this mean its now garbage?

If you do not get rid of those crystals are you getting accurate doses..

All my gear is stored in a closet ac runs around 74 degrees..

It only happens with the TNE..

Any suggestions..

Swoleoil's picture

1: Do not pin it if it has crystals. It will hurt and not be dosed correctly. Most of the hormone is in the crystals. Heat it until it turns all liquid then pin. If you can turn it to oil with a hair dryer your good. If it don't turn liquid go to step 2. If it stays liquid at room temp you are real good. Being that it is summer and it is crashed it will probably crash again. If this happens go to step 2.
2: Go to one of the great eroids accessory sources and order a 10cc vial of guiacol. It should be sterile but ask before you order. Add 1cc to the 10cc vial of tne and heat until it turns liquid with a hair dryer. If you can't get it to turn into liquid with a hair dryer then stick a pin in the rubber top so it can vent and put the bottom of the vial on direct flame from a stove for 1 second intervals while twirling the vial. Heat 1 second and twirl 5 seconds. Touch the bottom of the vial to your arm. As long as it is tolerable you are not overheating it. Let it sit for a few days and if it don't crash again it is fixed. If it does crash and you have room in the vial add 1 more cc and reheat. If that don't work throw it away and order from a different source. Hope that helps.

SenseiMiagi's picture

Legit advice here. Sticky worthy.

ChickenBirdOfGains's picture

^This^ Warming up your oil under some warm water definitely helps it draw smoother as well.