posted Mon, 01/23/2012 - 17:01
3106
Cloudy Test E
ad
I received a bottle of test from a board supplier one of two vials, and one of them is really cloudy like buckley's cough syrup cloudy.
I contacted them to see what gives, but I wonder if others have had this happen and what they did to remedy the situation?
I read that warming the solution works, but it's a temporary thing that should be sent back? Thanks for the help, I got this from my non usual supplier so not really surprised but curious anyway.
- Bookmark
- 0
- 0
AnonWhat I did was took a hand towel and soaked it in hot water, stuck that in the micro for 10 seconds wrapped that towel around the vial and gave it a shake for about a minute. After I noticed the cloudy was gone, but I had air suspended in the solution now. I put the gear away overnight, checked it the next day and you couldn't tell the difference between the two bottles of test.
Thanks Nasty your advice was spot on.
Give them a vote if you find it helpful.PermalinkWell done,....they will make an effective "gearhead" out of you yet :-) LOL
Test E has a melting point below that of normal body tempature.
I wouuldn't put it in a pan on the stove as they tend to have very uneven heat distibution. Just put some hot tap water in a pan about 3/4 the height of the vial and then give it a good shake ever minute or so.
Anonif its crashed, going with a low heat/medium heat pan will still fair better. On top of that, if its bad enough..they might have to re-bake the gear.
but like I said before.. it could have come from moisture in the raws when the supplier was making it.
Anonnothing wrong with it. heat it up and it will clear right up. put it on a frying pan on medium for a a little bit and it will be clear as a bell. dont walk off either it only takes a minute or so. put a pin in the top of it. 25g
or baking if you havent already done so.
simple body heat isn't going to necessarily do the job for you.
On the other hand, you could have cloudy test if moisture got into the powder when they were making your batch..
Nasty81Natethe test prolly got cold and crashed, no big deal bro....microwave a wet towel so its pretty hot, wrap it around bottle, and shake, shake, shake...shake your booty!
I just used your little trick on a bottle of Sust I got today that had what appeared to be crystals floating around in it. Worked like a charm!
AnonOk that worked perfect, thanks for that. I wondered if it was because it got cold, I hope it will stay in suspension now?
Give them a vote if you find it helpful.Permalink+points from me bro, thanks for that tip in case I ever run into this problem too. He can shake it like a shake weight or like he's jerk n it lol.