UncleYoked's picture
UncleYoked 5007
1921803

Titans.to

Estimated T/A: 
Shows up faster than the clap


Payment Methods: 
PayPal, Zelle, Cryptos, Vanilla, Western Union, MoneyGram, Walmart, Amazon, Cash App via BTC, Bank Transfer, Ali Pay, Handjobs

Please note

READ THE FAQ PAGE BEFORE ORDERING
We use MCT oil as our base carrier unless otherwise stated
For the fastest response, contact us by email at [email protected] Uncle is sometimes too busy to play
Always order by coming to eroids and clicking on the link. You will not find us on google, you will only find scam sites. Only use the eroids provided links to get to our website.

Never use SUGGESTED names for payments, you will get fucked and then it will be up to you to unfuck yourself.

We're a simple, farm to table operation. No flashy graphics or seizure inducing graphics, no advertisements, just organic anabolic goodness.
Our website is set up so there is no need for communication between any party, streamlined, simple and fast.
We are not careless reps working from a Chinese warehouse and we do not send your items from China or Russia, we are a US domestic source.
We're people, just like you and we put the people first. Unless they're assholes, in which case they can fuck off.

DeeMan's picture

Did you mean they aren't working that good? I know that situation you're referring to with that src. I was wondering how that turned out for you.

FlemDaddyKush's picture

Yeah those mk677 pills were very weak. Labeled 10mg. Ide say more like 2.5-5mg but probably on the lower side of the numbers I mentioned. I'm used to taking titans 25mg mk677 and if I take 4 "10mg" pills it's still not as strong as the 25mg from unc. The taste gave the pills away, they basically very very little bad taste when I chew the pills so I already knew that they could.not have much mk677 raw in the pills.

DeeMan's picture

Wow and if that truly is the case then what else of theirs is underdosed? Damn. Not good.

FlemDaddyKush's picture

Hopefully it's just low quality raws they used because I've bought powder mk677 from good reputable sources and it's been the low quality powder that didn't have a strong bad taste.

UncleYoked's picture

Probably cut, mk677 is a pretty expensive raw. It's more common to cut oral raws than inj but I've seen them all done over the years.
Worse one was tren cut with corn flour

UncleYoked's picture

You cannot mistake MK, don't give a shit what anyone says. It's impossible to cover up

swoleB's picture

No pain no gain. Man I will never forget the first time I put an mk677 under my tongue. UncleYoked should defenetley put a warning on the label.

Owes a Review × 1
UncleYoked's picture

It's on the product description, the label just says tablet instead of chewable tablet
https://titans.to/index.php?route=product/product&path=61&product_id=463

swoleB's picture

LMFAO never noticed it said that. (Tastes like beat up asshole, don't chew this one)

Owes a Review × 1
maxtom's picture

Shoutout to these guys. They have been solid for many years!

Trenplease's picture

I bought Test E vials last summer (1.5years ago) with expiration date 09/2025. I have them stored in a dark dry place. I use them for trt purposes. This is the second vial this happens- i draw with insulin pin 29G and when I brought it up to the light i could see few very small floaters in the gear. Last bottle i stopped using. This bottle it’s happening again. I always only use slin pins, so I don’t see how I could break the rubber seal. The vial when I bring it up to light has more tiny floaters. Other than filtering the gear- what else can I do? Is it safe to use? I’ve barely used 1/3 of the 10ml. Any suggestions?

Owes a Review × 1
swoleB's picture

I had that issue with a couple vials. I had those vials replaced by the titans team. Is it the vials with the small rubber seals? Why the hell are you drawing with a 29g? My suggestion to you is buy a heat pad. Put the vials in the middle of the heat pad and fold it in half. Let them sit for 15-20 minutes. Draw and pin. The heat softens up the rubber seal which prevents those tiny peices from breaking and going inside the vial. Never had an issue again since I started doing this.

Owes a Review × 1
Claudezilla's picture

This is exactly how I heat my darts but I roll it up it’s one of those heat pads from 25+ years ago so the it gets damn hot so I don’t use the highest setting but I have used the highest setting to uncrash some of my gear and it works awesome

In a promo × 1
Trenplease's picture

Yes the rubber seals are small.

I draw and pin with 29G like I said it’s for trt purposes.

I heat all the vials in hot water for few min before I draw and pin. I let the vial sit in hot water for a while after this suggestions today- I still see the particles.

If y’all think it’s crashed gear- it’s NOT- I know what it looks like- crystallized- had it happen before- this is not it! The particles seem to have a gray color just like the rubber stopper.

Owes a Review × 1
UncleYoked's picture

Those vials were recalled due to the rubber failing. DM me and we'll get them swapped out for you.

Tony Bag O doughnussss's picture

I got about 7 or 8 vials of the 100mg DHB I had to set aside because after a couple injections the rubber is floating around it never fails. All good though they are from last year

In a promo × 1
UncleYoked's picture

dm me

swoleB's picture

It's defenetley tiny pieces from the rubber seal. Those tiny particles as you call them are there to stay no matter how much you heat up then vial. Contact @UncleYoked or reply to the email you get when placing an order. Don't pin test from that vial no more.

Owes a Review × 1
Trenplease's picture

Is the rubber particles I injected gonna somehow be destroyed / removed by my body? I injected few very tiny ones in my felt

Owes a Review × 1
swoleB's picture

How do you know you injected any of those particles? I doubt any of those particles made it through the 29g. How's the injection site looking like? Any soreness redness ect?

Owes a Review × 1
UncleYoked's picture

That's strange, especially for test e, dm me some photos if you can. Try heating and shaking the vial a bit then let it settle and see if it's still there.

Trenplease's picture

Request sent

https://imgur.com/a/Cm8IoU0

Does this link work?

I noticed one of the particles is long and skinny- they all grayish color just like the rubber. I’m 99% sure it’s pieces of the rubber.

I pinned few tiny particles in my felt..

Owes a Review × 1
Trenplease's picture

I heat the vial every time before I draw- otherwise it’s almost impossible to draw with 29G. I usually keep it in hot water for few min. Today I kept it for like 30min, shook, still there. I’ll send u pic now.

Owes a Review × 1
jazzsnazz's picture

Been a customer for about 3 years, have always checked out using Wampum paying with Ducats, anyone know what this error is, have never seen it before?

UncleYoked's picture

works now

UncleYoked's picture

That's one of my fuck ups, started doing some security updates and it broke the mail server. So for the time being, orders may have a few errors. Feel free to dm with your order # so I can confirm it, may need to manually update a few things. Working on getting it back working asap.

dynnin's picture

Created my first account here to try to reach you faster. My first order with titans was seized, Order #*8675309. Please email me back

UncleYoked's picture

If true, probably not something you want written in the open.
I've accepted your FR

Greg's picture

READ

Greg's picture

THE

More by UncleYoked