posted Sun, 12/29/2013 - 17:10
992
Crashed?
ad
I've been running this for 8 weeks with no tren sides or results. I have run tren twice prior to this with intense sides and awesome growth. It looks as though there is a build up of solids at the bottom of the vial. Any one have experience with crashed gear?
Update. I put it in the oven for 30 min at 250. It cleared the bottom well. See pic. However, now its 3x darker. Could it be dosed too high now?
Ordered from:
- Bookmark
- 0
- 0
Put a pin in the top to vent then put it in the oven at 250 fo 20_25 minutes.
supernickI did it man. It's really dark now. Should I bag it.
It looks like you only had a cc or two in there it could be very overdosed depending on how much hormone you had sitting on the bottom.
Pin it. Let us know how it goes
supernickIt looks like coffee! Okay I'll pin 1/4 ML. That stuff is 300mg/ml.
I love tren when it's that dark.
supernickIt's done and I'm good. Thanks man.
supernickGot it. I put it in simmering water for ten. I pulled the plunger out of the dart for venting. It looks better. I'm just thinking it may be over dosed now.
Watch putting your gear in a bath. Bacteria could very easily get in your vial & you would end up injecting a infection. Just a suggestion but always use dry heat. Like a hair dryer or I even just roll the vial over a open flame of a Bic like a crack stem
the devils penis.
supernickLol. Roll it like a crank pipe. Good point about the water. Thanks for the response.
If it was crashed and you were pinning crashed gear you should of had some bad pip.
supernickHaha. Like a horse kicked me on the ass. But that isn't unusual. I was running centrino in the past and that stuff hurts. It's hard for me to use that as a gauge.
Can't see anything. The first one is so blurry. The others show nothing. Just warm it up with a hair dryer and see if it changes
supernickThe first is blurry. The third it shows a milky layer stuck to the bottom.