posted Tue, 11/06/2012 - 04:33
774
Cloudy Mast P
ad
Need some advice...
Nearing the end of my Test E/ EQ cycle, and am finishing with some Mast P. I have a few bottles of Mast P and one of them is cloudy. Just trying to see if you think its safe to pin, or should I cut the Mast short and not risk it? I already tried to heat it, but it made no difference in the cloudiness.
I sent a note to the source, and he says its fine to pin, what do you guys think. I have researched similar posts about cloudy gear, and some seem to say its fine and its only water, others say it could be contaminated. At this point, I'm not sure it's worth the risk...what are your thoughts?
- Bookmark
- 0
- 0
Thanks for the replies. No, there is no foam in it. I think what you are seeing is the back of the label through the glass...kind of looks like foam in the picture.
Anyways, I tired a blow dryer the first time and it didn't clear. Will try inserting a needle and using the boiling water in a pan trick. If it doesn't work, I'm just gonna toss it.
Just a question though, would the filter actually filter out bacteria? I mean if something was growing in it, would filtering it help? I don't think I'm going to bother, but just curious.
when I get get a bad vial of oil I would sale it to some one else . most of the sources here are good. but you dont know if it is bad stuff.
If it doesn't clear up I would stay away from it!
when you heated it did you vent it with a needle in the top? the cloudiness is probably moisture so if you heat it for long enough the water should evaporate. if it doesnt clear up after that i would be reluctant to pin it
If worried about it being contaminated I would buy a .22 micro filter and filter into new sterile vial. IMHO