posted Fri, 03/14/2014 - 00:10
1477
White crystals in tne
ad
I have a 30ml bottle of tne test no ester when I received it it had white crystals in it heated up in the oven at 250 for 20 or so min the crystals went away but 2 days later the crystals came back is the stuff still good
- Bookmark
- 0
- 0
I know this is an old post by information standards, incase you revisit this word to the wiser, make sure all the crystals are dissolved back into the oil or that will lump your ass up good and hurt like a biatch. I once was impatient and after I reconstituted my oil the second visit I had a little crystals floating around and instead of being smart and dissolving again I just pinned it and it felt like I injected glass into my muscle. if your going to be dumb you better be tough lol.
I just had that same issue recently with some Masteron... From what everyone said on here, and from the Lab i bought it from, your all good brother... Unfortunately the Masteron i had needed to be heated up every single time which made it to be a pain in the azz... Just follow the instructions SRC 56too gave, and repeat process...
Thanks
I get a coffee cup and put just a little bit of water and put it in the microwave for a minute. I put the vial in it to where it is halfway up the vial and give it a minute and shake it. You may have to repeat the process but this is pretty simple.
The other dayi got some tren enth and the same happend, i just got the hair dryier turned it up full blast and used that worked a treat, just rest the bottle up against sumit and set the hair dryer down infront and just leave it till the crystels go
I recently had a bottle of cyp that was so crystallized, it looked frozen solid. Boiled a pot of water and set it in for about 30 sec or so. Pulled it out and they were completely gone
Thanks
56tooIt is still good bro. Follow these instructions
Insert a syringe needle through the stopper just far enough to go through the stopper but not in the oil ( for venting pressure). Place vial in a pot and add water to pot til the water level comes up approx. 5/8 to 3/4 up the vial. Bring water with vial in it to a GENTLE boil. You dont want to boil it tooo hard as you risk the vial falling on its side and getting water in the vial, which would ruin it. Continue this and periodically stirring the vial by picking it up with your fingers. The process could take 20-30 minutes depending how bad its crashed.You wil at some point begin to see the rocks disolve. Continue this untill all solids have returned to liquid. Enjoy lol
Thanks for the good advice
God the oven??? Get a pan of water on stove top next time place a needle in the top of it and try that out!
Now I hate to say it but you should probably send me the rest of that 30ml TNE for proper research lol.
Give me ur address I'll send you some TNT dynamite lol thanks for the advice
Lol no problem yeah tne is really hard to hold suspension so pretty common to crash! Plus don't ever shake your bottle gently swirl it as you are heating it up!