Benny1818's picture
Benny1818
  • 287
1713

Test c vs test E

ad

Anyone know if test e will be better to build muscle /
less bloat?

Any PIP? I have the phamraaq ones test E 300 10 ml viles.

Also can I do a full ML in each delt?

Never went above .5ml per delt.

Benny1818's picture

Thanks bro. Appreciate it!

In a promo × 1
Birdmanjack23's picture

I've noticed that Test C when ordering in the winter time is less likely to crash as opposed to test E..

In a promo × 1
scoobydoo's picture

That's usually the opposite. Test c usually crashes in the winter.

ChuckThaDuck22's picture

A delt can hold more than 1ml, if your blend isMCT anddd dosed at 300 I’ve had zero pip, from multiple sources, 400 now that’s a different story,
Hot poker in my leg and limping around work

I’d feel comfortable with almost 2ml in my delt from a 27 gauge .5 inch even..

In a promo × 1
Benny1818's picture

lol. That is exactly the size that I use.

Not sure. I know it says test e 300 per 1ML

In a promo × 1
Rosschestzip's picture

I can’t do more than 1.2ish in my delts but if I stick to one I could probably do it almost daily(not recommended) just because there’s no soreness or anything. But if I go over 1.2ml i have a fucking dead arm, like Mayweather punched it

I use a one inch 25 gauge

Owes a Review × 1
TheIcon's picture

I am the same. I try doing 1.4+ and it doesn't seem to work correctly. Just easier for me to pin about .7 in my delt and then switch needle heads and to vent glute or something to finish it up.

ChuckThaDuck22's picture

You’re cycling @300mg a week yes?

In a promo × 1
Benny1818's picture

200mg. Will bump it to 300mg after next blood work I have lot of test e300 vials that i never tried yet. that’s why I was asking about the test e300

In a promo × 1
ChuckThaDuck22's picture

Well ya don’t gotta worry about pinning 1 full ml with the enanthate ester you’re looking at an active half life of 4 days around about so just pin .5 on Monday left delt, then Thursday night .5ml right delt..

Problem solved and you won’t have to worry about peaking and valleys .. if you had the Cyp I’m more in favor of pinning that once a week for a trt protocol

In a promo × 1
Benny1818's picture

Got it thanks.

In a promo × 1
Drask88's picture

Any issues with leaking? I’ve been leaking a bit lately since injecting more for my cycle and it ticks me off. It’s especially bad when I do delts.

I use the same needle type pretty much.

Rosschestzip's picture

Ya occasionally my delts will pour out oil, not even blood just clear oil. I’m always confused by it lol. The second I’m done pinning I just grab a napkin right away and gently hold it on the spot. You can also leave the needle in for a second after it’s finished.

Owes a Review × 1
ChuckThaDuck22's picture

Bro! That’s literally the only time and spot I’ll leak oil , like the finest bit because I leave the needle in long for a couple seconds but still.

It’s because we are using the 27g .5 inches. Because when I switch to my
One inch 25 gauge I’ll never leak the oil, I don’t think there’s much benefit to using “slin pin” size lengths I really don’t

In a promo × 1
ChuckThaDuck22's picture

I’ve leaked blood once when I pinned my delt, that’s the area I’m likely to bleed most that’s just how it is. It’s because the angle is weird and sometimes the barrel will twist and turn, that’s gonna cause trauma.

If you’re just going through the vein you’ll notice when you pull out its a fast jet of dark blood then nothing,.. there’s likely little oil in there as it’s gone past that surface vessel, are you leaking the actual AAS though?

That happened to me in the past due to not rotating injection sites, if I see oil leaking I try to gauge - okay that was like .5ml , then I just redose to compensate.

In a promo × 1
Benny1818's picture

After you inject, hold it in there for an extra 10 seconds

In a promo × 1
ChuckThaDuck22's picture

If you’re really crafty try as your injecting to pull the syringe out slowly and time it with the last push and then the needle is out, it’s creating a vacuum ..

But I do opt for the latter of the two and just hold my syringe in place for those ten seconds, sometimes with my finger still pressing on the plunge , as soon as that syringe comes out I already have a cotton pad pressed down hard and I press hard regardless for a good three mins to shut down any capillary trauma regardless.

Since I’ve been doing this I’ve bled once in the past three months

In a promo × 1
Benny1818's picture

Nice I like that. I usually hold down for 15 seconds. I will hold for 3 min.

Does a bruise the next day by pressing hard?
Talking in deltoid

In a promo × 1
ChuckThaDuck22's picture

I even manage to walk around and make those couple mins past, as I’m pressing down I move the arm around and massage the oil into it, any chance of bleeding then had the time to stop, and zero oil has leaked even in the event of puncturing through.

Zero chance of bruising , you’re just closing off a vacuum and letting the capillary clot so to speak. Works everytime for me

Not many will suggest this but I have most luck pinning quads, it’s just right in front of you, I shave the lateralis muscle, pasty white skin allows me to view the channel of veins, I poke around that and mostly never have to apply pressure,

I’m real anal and obsessive when it comes to the ritual of preparing and pinning, most guys on here will look at us with two heads going so in depth with this, but some just got the OCD some don’t,

Pinning quads 1inch pinning ventro 1.5 inch and both are 25 gauge

In a promo × 1
press1's picture

I’m real anal and obsessive

Shok Shok

ChuckThaDuck22's picture

Yess instantly regretted

In a promo × 1
Benny1818's picture

Damn you have it all figured out:)

I have 25 gauge 1 inch needles. Lour lock

I never did a ventro glute would like to. From what I understand it is in the center of the hip. Like by the bone. lol.

Tomorrow’s is injecting day. I wonder if I can do that dont want to hit a bone. Ppl say nothing worry about

I am ok with delts just the whole position is a little annoying

In a promo × 1
ChuckThaDuck22's picture

Okay well try this another member taught me,, listen up:

Take your right hand and face your palm inward and have that rest on your hip bone, awkward position.. but you’ll feel your thumb resting on a spot .. that’s your ventro inject spot

You’ll know if it’s bone lol the plunger will barely move

In a promo × 1
Chad P's picture

Aren’t you the hyper responder that pulled 1600 off 160 with high E2?

Owes a Review × 1 In a promo × 1
Benny1818's picture

Yes champ. Going to get my e2 tested on Friday
Been on a/I almost 4 weeks now.

In a promo × 1
Benny1818's picture

About to finish my test c vile.

Never tried test E

I don’t plan on bumping 1ML each delt till next blood work in another month. Was curious so I know for the future.

In a promo × 1
Jockstrap's picture

Theyre exchangeable unless you go high mg oils. How long have you been on cycle?

Benny1818's picture

8 weeks

In a promo × 1
Jockstrap's picture

Your other forum states you are already on cycle. So why?