posted Thu, 08/23/2012 - 07:22
1199
injection trouble
ad
I just pinned 2cc's into my right quad..i aspirated and got no blood..continued to inject. When i pulled the needle out blood started pouring out and a hard lump appeared immediately. This has never happened to me. Anyone know what it is?
- Bookmark
- 0
- 0
i bleed often, but the lump part to me suggests you need better plunger control. slow injects brother. what compounds were you shooting? tren especially should be a slow shot
Bostonim forced to pin slow because i use 25g pins. test only this round sir.
Nice! Slower is better.
always brother . thx for the plus
Plunger is key on everything. Much pip complaints solved right there. Thay was just good info! Things commonly overlooked cause the biggest pains.
Anonat least it wasn't a squirter.. I recall the first time it happened to goth.. looked the room looked like a damn crime scene. I was tempted to pull out the yellow tape and cordon off the room.
56tooWhat the hells going on with Goth Grrrrrl? One minute he's crying over his mis matching clothes the next he's squirting all over the room
BostonIve had that happen once to me. Luckily i heard prior that it isnt too uncommon and not a big deal so i didnt freak out too much lol.
ive only had 1 squirter and it landed in a trail about 2 feet from were I pinned. Surprisingly i didn't freak or anything, I found it funny as soon as i saw the blood on my floor. Also just barley missed the carpet which was lucky lol
Nicked a vein. Apply pressure. Might get a bruise. It sucks but happens. If aspiration was ok you'll be fine. Next time on that quad move down/up a good two inches.