posted Sun, 04/14/2013 - 17:51
1282
Forgot to sterilize the top of the vial
ad
I have sterilized the vial for the last few injections but this time I didn't. I didn't touch it since the last time I used it. I always grab the sides. I think it will be fine. What do you guys think? What do I look for if there is some thing wrong?
- Bookmark
- 0
- 0
Bro your fine you will definetly know if something's wrong. Don't stress bro
Anonyoud probaly know it quite quickly (within 24 hours ) if you were going to get an infection.
just dont keep doing it.
I think you should send me all of your gear so that I can inspect it for potential contamination.
GearofWarYeah like Rusty says, pushing microbes into the vial is super shitty because it can clusterfuck an otherwise perfect bottle of gear...We all know that gear abuse is worse than abscesses right? Lol!
You'll likely be fine, but don't do it again. Abscesses are painful and expensive to treat and I know by experience.
You'll live bro
youll be fine broski. YOU GET ONE PASS NEVER AGAIN
I'm pretty religious about my injection routine. But I guess my brain was somewhere else! Nothing like a little scar to keep you in check!
.. your going to die.
AnonYou are terrible! I sent you a FR you Ahole!
lol.. I joke incase ya don't know ;-) FR accepted darch.
I honestly think you dont have anything to worry about.Its not like u are reusing the needle.Although i always wipe top off.
AnonLol bro your good just wipe it off from now on ! You'll know if something goes wrong and honestly half the time people think something's wrong and if they wait about a week the see there good lol
Odds are you'll live.
As rusty stated, watch for signs of infection.
...Don't stress too much over it.
RustyhookerPain. Swelling. Heat. Badic infection signs. Wiping the top is to kill anything growing there as that is possible. Also as you pin the rubber you risk pushing microbes into the vial