posted Sun, 02/17/2013 - 12:32
1451
Drawing from two vials.
ad
I have a small amount left in one vial and am nearing the end of a second. can I draw from both using one needle so I can finish the bottle or is it wasted and I should just leave the little in there?
- Bookmark
- 0
- 0
Anoni do it all the time.... but im very very clean with my vials and pins..... i wipe everything before and after use.... where the gear sits gets alcohol before i sit it on the counter..... very maticulous with my gear..... and of course change the needle
lol i have had an infection before so i over do it these days
Just draw from as many vials as you like, just change the tip! if not the tip will be dull and the term "JABBING" really applies haha
I usually stick two pins out if each vial. Draw the gear into the same syringe, twist off and put a new pin.
Sorry I forget there are a lot of people who here and not everyone remembers what I'm running. It's the same gear. I I always draw with one needle and pin with another. I was just curious if it would be an issue with cross contamination. I do always wipe the top down also. I just wanted to ask. I better safe than sorry. I def don't want to waste it I want every last drop lol.
thumbs up to ward and killinit, not much more to say about it... not fully understanding your reason of concern?? are you afraid of cross contamination? there are sterility procedures to follow, make sure you use a fresh alcohol prep wipe on the rubber top of each vile before drawing, do not touch or allow the needle to touch anything, you can draw both oils into same syringe for injection (for example you can draw a cc of NPP and test PROP into same syringe for a single injection), prior to injection you will change out your drawing gauge needle (for example I use 20-22G), and use a 23-27G needle 5/8th" - 1.5" length needle for injection (depending on the site, I just use a 1" for all personally).. of course making sure to use a fresh prep swab for injection site, using circular motion from center out to clean skin... anyways all of this can be looked up easily and researched.. you should try to look some of this info up.
Wardi77Same compound in both vials? Either way I dont see why you wouldnt draw as much gear as you possibly could from every vial. Why waste it? I never inject with the same needle I draw with. I inject with a 25gauge and draw with a 18gauge. If both compounds in the vials are the same as far as oil based then you can use the same needle, but if one compound is water based and the other is oil then change needles, but then again you should never mix oil/water based in the same syringe so I really do not fully comprehend what you are asking.
Why the fuck would you waste it? draw that shit up in the same syringe. Just make sure you change the needle before you pin
X2