posted Sat, 09/28/2013 - 10:09
3230
Heating gear with high BA content?!
ad
Anytime I use more than a half cc of test e 300 mg/ml I have extreme pip within 24 hours, most of the time 12 hours that lasts for days, Does anyone have any suggestions as what to do? besides throw it out lol. I am shooting a cc of another oil with it as well that doesnt give me pip.
- Bookmark
- 0
- 0
BigBmajI've also tried cooking the alcohol out of it before. I heated it as you mentioned and it was better afterwards. I just don't know enough about cooking BA out of solution to say anything for sure.
BigBmajWhat I did was fill an empty bottle with grapeseed oil from the health food store I wanted clean organic shit. Then I put it in the oven at 220 for 20 minutes with a pin in the top to vent it out. I used that oil to dilute the painful shit and it helped a great deal.
Dilute it in your barrel with GSO.
TropicanaJuiceWhen I said heating I was referring to cooking it? I heard once if u baked it at 200 degrees it would help? Idk
Bro, you can't be serious. Where the hell did you hear that? Scroll down and read my previous posts. Sheesh.
TropicanaJuiceRead it briefly on another forum, it said to heat it once and only once, obv not inject yourself with it heated that high lol, but I've heard of people baking there gear
You MAY just be having an issue with the EO in the mixing of the gear, Mate. Contact your source and ask them IF they use higher doses of it than in your other gear. For me higher concentrations of EO, especially in Test E mixes, gives me EXCRUCIATING P.I.P that has kept me out of the gym for over a week in the past. No matter where I pinned it, the P.I.P was unbearable.
Also, just a quick tip. Instead of just warming the loaded barrel with the hair dryer, try warming the vial with the hair dryer, drawing you fluid into the barrel and placing it under your arm pit for 10 minutes or so to get the juice to body temp before injecting it. (Easier than just holding the damn thing. LOL).
TropicanaJuiceYa the thing is the 1-test cyp I'm using has EO oil and I get no pip from it
I'm no chemist, Mate. But MAYBE it's down to the dosages of EO being used in the mixing?
The last Test E I purchased, as I said, REALLY kicked my ar$e. I contacted my source about the issue, explained to them what was happening and they recommended that I dropped Test E altogether and to try Test Cyp for my cycles Test needs.
It worked. FOR ME.
No more P.I.P/Abscess issues whatsoever. I pin-up with the Test Cyp 3 times a week into the glutes, (As well as the other compounds within my cycle into the delts and quads), and I haven't had ANY issues since changing the compound.
MAYBE it's an option open to you for your Test needs too, Mate.
EDIT: My bad, I forgot you'd said you were already using 1-Test Cyp in your reply.
56tooI dont think you're referring to BA. I believe its probably more EO which you may be allergic to. Most people aren't allergic to it but you may be. .Many chemists use more EO as the dosages get higher.
Before trashing it, try diluting it with GSO (sterile grape seed oil). Just draw the same amount of the GSO as you draw of the gear. For example: draw 1cc test e, then draw 1cc From the GSO vial. Roll the syringe around and turn it end over end to mix it well within the syringe. Then fire away as you normally would. Let us know how it works out bro. Good luck
Send it to me an i'll use it :). Seriously though, heating it before inject might help. Depending on where you shoot, you can foam roll the area afterwards to help disperse some of the oil. Does this happen to you with any test e over 300? Could be just this brand has a high ba content
It doesn't need to be heated very much. Simply hold the loaded syringe in the palm of your hand for several minutes. That's all the warmth you need. Too much heat is not good.
TropicanaJuiceWell I heated up the barrel with a hair dryer and had a shower before, but no I've used test e before and it was fine