posted Sat, 06/09/2012 - 17:38
5893
Pain and hard around injection site...?
ad
Hey, 2 weeks into test e cycle. I been injecting in my glutes, anyway first time I did it next morning pain in the area and hard then 3 days later I did it on same side but different spot and same thing again, I switched sides this time and once again same thing.. this is my first time using injects. there is no redness/bruising/fever etc. just pain and hardness around the injection site... just wandering if this is completely normal, if I should go get it checked out or what.
- Bookmark
- 0
- 0
Rustyhookerhttp://www.eroids.com/forum/general/general-talk/ways-to-avoid-pip
This is how
this is what im talking about! god dammit
My first couple of pins were extremely painful. I had pip for an entire week till my next pin. I had blackness and extreme soreness around the pins.
My only theory I have as to why this was painful is that my source uses EO oil or too much of something else. Maybe it was virgin muscle or my pins absolutely sucked donkey ass lol
RustyhookerBlackness??? Bruise or dead tissue?
how long did pip last?
RustyhookerEdit
yo, this shit is happening to me right now. did the pain go away? and if so, how long did it take to go away?
my ass hurts so much i cant even bend down.
CHEERS
RustyhookerThis post is 11months old. Pin size? Cycle? Stats? Rotation? What do you do for injection procedures?
yea i know its old, i just wanna know how he overcame the pain.
I use 2 cc intramuscular needle, test.e 250x2 a week + 30 dbol a day.
Donno what rotation is, but i inject the needle straight in, not letting it being inserted diagonaly and always all the way in.
RustyhookerSo...you're using a insulin pin that'd 29 x 1/2. Dont know rotation? Unsure proper technique.
Post info that'd been requested or scan the 1000 posts on PIP.
sorry, ment to say 2 ml and the size is 0`8x40mm or 9/16". and i0ve been pinning myself (not steroids) for over 10 years. dont question my technique.
RustyhookerLmao! You posted bout pain. Then piss on folks helping. Man up. Its pip. Pins too damn short!
how the hell are you helping? you just asked a bunch of questions
He can't help you without know the answers to some of those questions.. I d ask a few myself but I m concerned that you'll think i m being bossy and overbearing .. it is helpful to know the full situation prior to giving some advice .. there are many many reasons why you have pain and hardness at the injection site and without having all the facts prior .... trying to figure it out is like trying to find a grain of rice in a haystack.
RustyhookerI know...you're a true steroid guru. I'll contact you first when i start #17 this fall. Those wuestions would be all nuisance since im such the rookie.
Now peep the top line.
Kalpa does that to me too. I have some Eq and Test E that after every injection leaves my site hard and a bit sore. I believe it is the solvents/carrier that is doing that to me. One thing I know for a fact is that it is some potent gear and I am very happy with it.
Kalpa is good. Needle is good size. Maybe it's your body not liking that oil. is origionsl site absorbing?
mattyjay25Yes the first inject spot has no firmness or pain just the one from 3 days ago and the one done today. hard to train like this, so I just wandered if it had to be checked out or if it was just my virgin muscle..
Sust was l ok ke that for me til i got fully into the glute. My butt has ghetto to it. if its absorbing...you'll have to make sure its fully into glute. Between glute n fat leakage does hurt. As long as its absorbing...virgin muscle can suck. Forums...read up how to warm juice and hot pad if possible to disperse the oil. Hot water on vial to thin the oil. Or set half deep in hot water for ten mins. Sust for me had painful propellant so it takes tricks to help. Fully read up inj sites because you're on split inject style of cycle. If it wasn't painful of maybe test on quads too for extra sites. Warm oil disperses easier. Also.....don't simply force the oil into the site after adpiration. Use lil more gentle pressure on plunger so oil can have a chance to go into the muscle areas. If the site gets hot fever and you're having bad isdues then yes...have it checked.
mattyjay25thanks for the great info
Hope it helps. At least your rotating sites. And if lumps aren't absorbing over the week just keep eye on things. For me the sust i used did same deal. Next time i will use different brand. Body didn't like it. Lol
mattyjay25its 3 cc needle but I am injecting 1 cc right 1ml?
sorry newbie...
mattyjay25also its kalpa brand if that changes anything, I read a few people on here had bad PIP with it
mattyjay251 cc 23 gauge 1.5 inch. bad product really?
1cc wtf are you going to do with that. Thats like hiring a midget(AKA Kickable) for your basketball team.
1cc?
Read his other forums.....possible troll.
or bad product, hate to say, but had to add
Agree!
Pin size? How many cc's? Hardness can be different things. Could be irritating propellant. Or deposited between fat and muscle.