austinvail's picture
austinvail
  • 8
6310

Best size needles to use

ad

Hello was just trying to make a post of what needles you guys use per injection site... noticed many use different sizes. could you post up what you personally feel is best per each injection site you have used.

also is it really needed to use a separate needle to draw and one to inject?

Glutes: 1 site
Deltoids: 3 sites
Biceps: 2 sites
Triceps: 3 sites
Lats: 1 site
Pectorals: 3 sites
Quadriceps: 2 sites
Traps: 1 site
Calves: 2 sites

bbqman55's picture

Can you inject with a 21g 1.5 inch needle in the glutes?

onelove's picture

Where to purchase? Can't get them anywhere around here do to a bad drug problems.

onelove's picture

How many ccs should the syringe hold?

Keez's picture

21g to draw
23g to bang
Both 1.5 inch pin
Quads or glutes
Oils flow easy enough at these gauges.

greg82917's picture

Ive used 25g and 23g in the past with a 1 1/2 inch needle, buried all the way in my quad, butt, or shoulder. 25g takes a while but is slightly more comfortable.

cowcow's picture

I use 23 g 1". I suppose you could try 25 g, but if the oil is thick you'll be there for a while.

I take
1.5 inch needle in the glutes
20g in the quads and calves.
23g, 1" for quaderinos

stevica's picture

I use 23g 1 1/2 for glutes, it's pretty much pain free and goes a lot faster than 25g

TINYTIM36's picture

20G to draw with, no air bubbles nice clean pulls. 25G 1" delts and thigh. Glute 25G 1 and a half.

xalzlos's picture

23G 1-1 1/2 is the most basic, you can draw with it, without spending 20 min trying to get the oil out ( im exaggerating lol) and it doesnt hurt either, can easily go glutes with 1 1/2 ( can probs even do it with a 1 incher)

knuckleswollen's picture

If not in amps I use 2 needles. A 21g to draw and 23g 1.5 to inject I only inject in glutes. Rotate cheeks lol. 23g I usually roll with 1 thicker oil 25g is to hard to push

ashop's picture

I use 25g 1.5 for glutes
and 1" for elsewhere,,,delts,,biceps,,ETC..
The best pins IMO are B-D Precision Glide.

Youstolemyname's picture

I've used the same needle to draw with for years. No problems here. 23g and i prime it just before the injection.

Hustle28's picture

Never use the same needle u draw with!!

I use 21g to draw and 25g 1" for glutes/delts/quads

thebigK's picture

I used to draw with an 18g and it went super quick, and I'd pin with anything from 23-27g. I started drawing with a 22g and notice the big difference in draw time. The thing is I feel the 22g doesn't damage the vial the same way...after awhile with the 18g you get a bunch of little plastic chunks in your gear.

I always swap needles due to what Steve says, I like my needles sharp.

In a promo × 1
mightymouse1000's picture

Personally I switch my pin from when I draw to when I inject, I heard it dulls the needle and for me seems go in smoother. I use a 23 to draw and shoot. I used to use 25 but sometimes it can't push thick oils

T-Rex's picture

Hey Steve im running my 1st cycle of Balken Test E soon and was wondering if you think this is a thin or thick oil? I'm planning on pinning in my glutes. Also what gauge would you recommend for drawing and at what ml? Im planning on running a 12 week cycle at 500mg per week w/ 2 pins(250mg each). Thanks in advance.

Owes a Review × 1