posted Thu, 05/09/2019 - 16:35
1029
Trouble drawing gh after mixed
ad
Some times when I mix my water and hgh it's really hard to draw. It doesn't happen to every vial but probably one or two a kit. I let it sit in the fridge after i mix for about 30 mins or if I finish a vial I make another one at night for the morning so I can pin first thing am. It will literally come out so slow like little drops of water. anyone else have this problem? Is it the gh or is it because I 'm not rolling it in my fingers after I mix to get the little clumps to mix? It'll be fully dissolved when I pin. Maybe not enough water? I use 100iu of bac water per vial.
- Bookmark
- 0
- 0
This is an easy one, it works fine every time you let air inside, if there is a vacuum inside the vial, you will be struggling pulling anything out, that’s for all PED’s not just HGH including peptides.
Once you mix your HGH, get your syringe out and insert the amount of air inside the vial that equals the amount of HGH you want to use.
I did it this morning and worked like a charm. thanks brother
That’s great, enjoy man
These guys below got it, took me a while to realize myself when I first started GH, it’s the vacuum seal.
Guys below nailed it! Ley air into the bottle as you do wit hall injections.
Inject the amount of air into the vial that you intend to draw.
I will start doing this from now on. Thanks
If there is a heavy vacuum on the vial you need to stick an empty pin (without syringe) through it to equalize the air pressure first. Then when you want to draw from the vial inject an equal amount of air in that you tend to withdraw.
I do a 4iu split am pm and I did what you said 2iu of air this morning and it worked great came right out. Thanks brother
Maybe its because you pull up with your sling needle if you push your needle trough the stopper it can make some damage to the needle whats make it difficult to pin also
I always flip my vial so i pull downwards.
RustyhookerVacuum in the bottle.... try letting in air
basskiller89I've never had that problem, I usually use 300iu per vial so that I can get the most bac water per dosage of gh. That way those little drops after you pin aren't high concentrated. You could try new slins pins, I've never run into the problem
So for one IU of gh you have to pin 30 on slin? Don't you want the least amount of water?
basskiller89I have 2000mg peptide vials, so it comes out to about 125mcg per 20iu
For a 10iu vial of gh it would come out to about 30ius for 1iu of gh yes
I personally would want the most water per IU so anything that drips out is less, if a drop of 30iu=1iugh drips out it far less than a drop of 10iu=1iugh is my reasoning
I see what your saying that makes sense, I might try that with one of my kits.