posted Wed, 12/17/2014 - 22:56
714
blood
ad
I'm not sure if I'm posting in right spot bare with me I'm a rookie. I shot up in the dealt today with a 23 gauge 1 inch pin and I did aspirate no blood but when I took the needle out it wasn't pouring but I had flowing down the arm. I drew a circle around the spot that I shot its within the tattoo. Should I have shot higher lower could use the advice thanks for your time
- Bookmark
- 0
- 0
Appreciate all the great responses and 2 inches higher sounds good I was thinking I may have shot a little to low don't mind blood just don't want to lose my product
I would aim 2 inches higher
juiceboxx1212After you inject keep a little pressure on the plunger for 10 secs or so. Then wait another 15 or so seconds before removing the needle. By introducing the oil into the arm you add a little pressure into the shoulder after waiting 10 or so seconds it should minimize the bleeding significantly.
Hey appreciate the info and ya I hit up spot injections .com I feel like I'm hitting the middle of the dealt but from where my circle is should I go a tad higher or a tad lower
Dead center of your tat is the spot. You're a little low.
hunteron20sI do 2 fingers from the top of delt .that works for me
It happens every now and then.
spotinjections.com!
hunteron20sIf you hit a vein and went through it thats why it bleed after you pulled out ..